FORTISVEX Wisconsin State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets

Once you reach 6x10 feet you have left house flags behind. Sixty square feet is commercial size for a commercial flagpole, and this is the last size built with grommets before the construction switches to rope.

This is the Wisconsin state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Wisconsin flag specification

The Wisconsin flag is set out in Wisconsin Statutes Section 1.08, at a two to three proportion. It is the state coat of arms on royal blue, with the word Wisconsin above and the date 1848 below.

Originally 1863 and standardized in 1913; the word Wisconsin and the date 1848 were added by Chapter 286, Laws of 1979, mandatory for flags made on or after May 1, 1981.

The law governing this flag addresses design, colors and the seal or emblem, but leaves overall size unspecified for a modern outdoor flag. That is typical across most states, which is why the industry has converged on the same standard sizes.

We reproduce that design faithfully, in the standard outdoor flag sizes the whole industry uses and that the states themselves buy. What matters on an outdoor flag is that the colors, the seal and the emblems are right, and they are.

The law that defines it, in its own words

Wisconsin Statutes Section 1.08 reads:

(1) The Wisconsin state flag consists of the following features: (a) Relative dimensions of 2 to 3, hoist to fly. (b) A background of royal blue cloth. (c) The state coat of arms, as described under s. 1.07, in material of appropriate colors, applied on each side in the center of the field, of such size that, if placed in a circle whose diameter is equal to 50 percent of the hoist, those portions farthest from the center of the field would meet, but not cross, the boundary of the circle. (d) The word "WISCONSIN" in white, capital, condensed Gothic letters, one-eighth of the hoist in height, centered above the coat of arms, midway between the uppermost part of the coat of arms and the top edge of the flag. (e) The year "1848" in white, condensed Gothic numbers, one-eighth of the hoist in height, centered below the coat of arms, midway between the lowermost part of the coat of arms and the bottom edge of the flag. (f) Optional trim on the edges consisting of yellow knotted fringe. (2) The department of administration shall ensure that all official state flags that are manufactured on or after May 1, 1981 conform to the requirements of this section. State flags manufactured before May 1, 1981 may continue to be used as state flags.

The emblem itself is defined by reference to the coat of arms at Section 1.07, so these words are the frame and not the whole picture.

You do not have to take our word for any of that. Read Wisconsin Statutes Section 1.08 in full at the Wisconsin Legislature, and check what we sell against it.

This is the flag we make. Not an approximation of it.

What is on it and what it means

A sailor and a miner represent labor on water and on land. The shield quarters agriculture, mining, manufacturing and navigation. The crest is a badger and the motto is Forward.

Worth knowing about this flag

The lettering was added for a specific reason. Without it the flag was nearly indistinguishable from several other blue seal flags at a distance, and that is why the 1979 act required it.

Where the Wisconsin flag flies

The Acuity Insurance flagpole in Sheboygan is the tallest flagpole in the United States at four hundred feet, erected in 2014. It weighs approximately four hundred and twenty thousand pounds, uses three pendulum style tuned mass dampers to reduce movement and vibration, and is designed to withstand a low temperature of minus forty two degrees. The current flag is seventy by one hundred and forty feet. The original was sixty by one hundred and twenty. Flags fly about a hundred and twenty to a hundred and thirty days before retirement, and a heavier flag is used in harsh weather.

Fly it on Wisconsin’s birthday

Wisconsin became the 30th state on May 29, 1848. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Wisconsin flag has an official reason to go up.

Order it ahead of the date and it is ready to fly that day. Every state’s birthday is listed on our state birthdays page.

Nylon or polyester in Wisconsin

Nylon inland at Madison. Polyester on the Lake Michigan shore at Milwaukee and Green Bay.

For scale, the National Weather Service ultraviolet index forecast for Milwaukee on July 23, 2026 was 9 at solar noon, in the very high band. That is the sun this flag has to survive.

At sixty square feet, firmly commercial territory, the material choice on an exposed site above decides between one season and three.

You are looking at the nylon here, the right pick for the sheltered and moderate wind sites named above, for any house bracket, and for anywhere the flag gets brought in during storms. Two things make that case. It is light enough to move on the breeze most yards actually get rather than hang limp, and it dries fast, which keeps mildew away in a humid climate. What it trades away is ultraviolet durability — nylon’s amide bonds break down under ultraviolet light, losing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. For one of the exposed sites named above, the polyester version is the better fit.

The part most buyers learn only the second time around: nylon flies in wind too light to move polyester. When it matters that the flag is actually moving — a still morning, a holiday, a funeral, a ceremony — that favors nylon even somewhere polyester would last longer. A flag that hangs motionless is not doing its job either, however durable it is.

The number most institutions rely on traces to the American Legion, which reports a roughly ninety-day expectation from the federal government for a flag flown daily sunrise to sunset, and about a quarter of that flown around the clock. Retailer experience puts nylon at three to six months daily, polyester at four to eight, and an occasionally flown flag at one to three years. These figures are practical guidance, not a warranty, and exposure will move them considerably.

How the 6x10 Feet is built

Six rows of lock stitching replace four at this size, because sixty square feet generates far more force at the fly end than any house flag experiences. Four rows would not hold.

The arithmetic behind that: 60 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind the fly end of a flag this size travels faster than the wind itself, because the wave running out to the tip accelerates as it goes. That is why the tip wears out first and why the stitching count at that end is the number worth reading on any listing.

Two people and a clean, open surface are what this size needs for a proper fold. A tailgate will not do at sixty square feet.

Each lock stitch knots into the one beside it, so a broken thread stays broken right where it snapped instead of unraveling the whole seam. 6 rows is not 6 times the strength — it is 5 backups. At sixty square feet, the heading takes the most sustained strain of any part of the flag, which is why it runs two inches of reinforced heavy duty white with brass grommets and tooth washers.

This flag is commercial grade nylon, light enough to move in a gentle breeze, and it sheds water instead of soaking it up, drying fast — which matters, since a wet flag is a heavy flag that works its own seams harder. UV resistant, field tested ink is what stands between the flag and the sun, since sun is what fades a flag over time.

Why this flag is harder to make than most

Two human figures, a quartered shield, a badger crest and two lines of added lettering. The lettering is what makes it identifiable and it is also more to print.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Wisconsin flag placed 65, at 3.16 out of 10.

Will it fit my flagpole?

This size wants an in-ground flagpole between thirty and forty feet.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

The last size on grommets

Above this size, every flag switches to a full-length sewn rope instead of two grommets, because two points can no longer bear the load. The 6x10 foot flag sits right on that line, which is why it carries six rows of stitching and a two inch heading while still keeping grommets.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Underneath both tables is a single ratio: a flag a quarter to a third the flagpole’s height. When you land between two rows, that is a real choice, not a rounding error — smaller flies more often, bigger reads further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Above roughly a hundred feet of flagpole, the quarter to a third guide keeps its accuracy but loses its simplicity: the flag now has to be specified alongside the truck, the halyard, the foundation and the wind load as a single system, and skipping that step is how a flagpole gets damaged rather than the flag. Several famous installations fly flags larger than the rule on purpose, with an engineer deciding it rather than a table.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

Every printed flag looks right from one side and mirrored from the other, and that is simply how the overwhelming majority of American flags are built. Making both sides read correctly means building what is really two flags stitched together over a liner, at roughly twice the price and twice the weight. Single sided is the standard, and it is the right choice unless a state’s statute specifically requires otherwise.

Flying it with the United States flag

Governing this is Title 4, Section 7 of the United States Flag Code, which keeps the United States flag in the position of honor: never below another flag, never to the right of one at the same level, meaning never right of the viewer’s left. Two flagpoles at equal height put the United States flag at the viewer’s left with equal-sized flags; unequal heights put it on the taller pole; a single flagpole with two flags carries it at the top. No penalty attaches for private citizens under the Code, but it is what institutions follow as standard practice.

Buy two and they both last longer

Keep two flags and swap them monthly. That single habit will outlast three flags run to destruction, since resting fabric recovers and the fly end is spared the repeated wear of constant flying. Take the flag down ahead of severe weather, since one bad storm night can outdo six calm months. Watch the fly end rather than the center; a little stitching early saves a whole season.

For cities, counties, schools and agencies

Cities, school districts, fire and police departments, courthouses and state agencies buy state flags from us as a matter of routine. The tax exempt page is where a tax exempt account is set up; the contact page is where quantity orders, replacement schedules, and sizes not shown here get handled.

Why buy it from us

We are a small American company and we stock what we sell. Every flag here is made in the United States, printed in UV resistant ink, and finished to the construction described above rather than to a price point. We would rather sell you one flag that lasts than three that do not. Free shipping on orders over twenty five dollars.