FORTISVEX Arizona State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets

Once you reach 6x10 feet you have left house flags behind. Sixty square feet is commercial size for a commercial flagpole, and this is the last size built with grommets before the construction switches to rope.

This is the Arizona state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Arizona flag specification

The Arizona flag is set out in Arizona Revised Statutes Section 41-851. It is thirteen rays, seven red and six gold, over a lower blue half, with a copper five-pointed star centered. The statute goes further than most and gives a four foot hoist and a six foot fly with a two foot star, then adds that the same proportions apply to flags of other sizes.

Adopted February 27, 1917, becoming law without Governor Campbell’s signature, having grown out of a 1910 rifle team banner designed by Colonel Charles W. Harris; the first official flag was sewn by Nan Hayden.

Arizona is one of the few states where the standard size and the statute agree. Section 41-851 specifies a four foot hoist and a six foot fly, then states that the same proportions apply to flags of other sizes. A 4x6 foot flag is exactly on specification.

The reproduction here is faithful to the design, in the standard outdoor sizes used industry wide and bought by the states themselves. On an outdoor flag, correct colors, seal and emblems are what counts, and that is what you get.

The law that defines it, in its own words

Arizona Revised Statutes Section 41-851 reads:

A. Blue and old gold shall be the colors of the state. The blue shall be the same shade as that of the flag of the United States. B. The flag of the state shall be of the following design: The lower half of the flag a blue field and the upper half divided into thirteen equal segments or rays which shall start at the center on the lower line and continue to the edges of the flag, colored alternately light yellow and red, consisting of six yellow and seven red rays. In the center of the flag, superimposed, there shall be a copper-colored five pointed star, so placed that the upper points shall be one foot from the top of the flag and the lower points one foot from the bottom of the flag. The red and blue shall be the same shade as the colors in the flag of the United States. The flag shall have a four-foot hoist and a six-foot fly, with a two-foot star and the same proportions shall be observed for flags of other sizes. C. The flag represents the copper star of Arizona rising from a blue field in the face of a setting sun.

You do not have to take our word for any of that. Read Arizona Revised Statutes Section 41-851 in full at the Arizona Legislature, and check what we sell against it.

It is the real flag we produce, not a simplified version.

What is on it and what it means

The statute describes the copper star of Arizona rising from a blue field in the face of a setting sun. The thirteen rays are the original colonies. Red and gold are the Spanish colors carried by Coronado. The copper star marks Arizona as the largest copper producing state.

What most listings get wrong

The thirteen rays do not represent Arizona’s counties. That error is everywhere. They represent the thirteen colonies, and the statute is clear about the setting sun.

Where the Arizona flag flies

The SGA flagpole in the Scottsdale and Phoenix area, about two hundred and five feet, described by the contractor as Arizona's tallest. It required a City of Phoenix height variance from ninety feet to two hundred and five feet and Federal Aviation Administration approval near Scottsdale Airport.

On December 7, 2025 a skydiving team flew a three thousand two hundred square foot United States flag in freefall over Eloy in a certified Guinness attempt to reclaim the freefall flag record. An event record connected to Arizona rather than a fixed installation.

Fly it on Arizona’s birthday

Arizona became the 48th state on February 14, 1912. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Arizona flag has an official reason to go up.

Get it now so it is flying on the day itself. See every state’s birthday on our state birthdays page.

Nylon or polyester in Arizona

Polyester statewide. Extreme ultraviolet at Phoenix, Tucson and Mesa, monsoon downbursts from July through September, and dust abrasion. Nylon only for shaded or short term display.

This is a commercial flag at sixty square feet, and on the exposed sites named above, material choice separates a one-season flag from a three-season one.

This is the nylon listing, suited to the sheltered and moderate wind sites named above, to any house bracket, and to anywhere you bring the flag in during storms. Two factors drive that choice. Nylon is light, catching the breeze most yards actually get instead of hanging still, and it dries quickly, which is what keeps mildew at bay in humid air. The cost is ultraviolet life: nylon’s amide bonds absorb and break under ultraviolet exposure, fading faster than polyester, and it loses about a tenth of its strength wet. On one of the exposed sites named above, look instead at the polyester version.

Here is the part usually learned the hard way, after a second purchase: nylon catches wind on days polyester simply will not move. When the flag needs to be visibly flying — a quiet morning, a holiday, a funeral, a ceremony — that argues for nylon even on a site where polyester would technically last longer. A flag that just hangs there is not doing its job either.

Most institutions work from the same benchmark, reported by the American Legion: the United States government's expectation is roughly ninety days for a flag flown daily sunrise to sunset, and about a quarter of that for one flown around the clock. In practice, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for a flag flown only on occasions. These are working numbers, not a guarantee, and exposure can move them substantially either way.

How the 6x10 Feet is built

At sixty square feet the force at the fly end outstrips anything a house flag sees, which is why the stitching steps up to six rows here instead of four.

Work the numbers and you get 60 square feet of nylon at roughly two ounces a square yard. At thirty miles an hour, the fly end actually outpaces the wind, because the wave running to the tip accelerates along the way — the reason the tip fails first, and the reason fly-end stitching count is the number that matters.

Folding this properly takes two people and clear ground or a clean surface — sixty square feet will not fold neatly on a tailgate.

A lock stitch ties into the stitch next to it, so one broken thread does not unzip the whole seam — it just stops. 6 rows is not 6 times the strength; it is 5 backups. This size puts the most sustained strain on the heading of anything on the flag, so it is built two inches wide, heavy duty white and reinforced, with brass grommets and tooth washers.

This is commercial grade nylon: light enough to fly in a light wind, quick to shed water instead of holding it, and fast to dry, which matters because a waterlogged flag is a heavier flag putting more strain on its seams. UV resistant, field tested ink is what fights the sun, which is the real driver of color loss over time.

A design that reproduces cleanly

Thirteen rays and a precisely placed star mean the printing has to register accurately, and the copper of the star is a color most presses render as an orange tan.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Arizona flag placed 6, at 7.92 out of 10.

Will it fit my flagpole?

This size wants an in-ground flagpole between thirty and forty feet.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

The last size on grommets

Past this size, construction shifts entirely to a sewn rope the length of the heading, since two grommets cannot carry the load any further. The 6x10 Feet sits exactly at that boundary — six rows of stitching, a two inch heading, and still grommets.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

The rule that governs both tables is a length-to-height ratio of about one quarter to one third. Borderline cases favor the smaller size if you want it flying often and lasting, or the larger size if the point is to be seen from a distance.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The quarter to a third rule holds all the way up, but above about a hundred feet the flag and the flagpole stop being two purchases and become one engineered system: the truck, the halyard, the foundation and the wind load all have to be specified together, and a flag bought without checking the flagpole rating damages the flagpole first. Several famous installations deliberately fly longer than the rule, which is a choice made with an engineer rather than from a chart.

If a size in either table is missing from the website, it does not mean we do not carry it. The full range is available to order regardless of what is currently listed.

About the back of the flag

A printed flag reads correctly from the front and reversed from the back. That is normal and it is true of almost every flag flown in the country. A flag that reads correctly from both sides is a double sided flag, built as two flags sewn together with a liner between them, and it costs roughly twice as much and weighs roughly twice as much. Unless the statute for a particular state requires it, single sided is the standard and the right choice.

Flying it with the United States flag

Title 4, Section 7 of the United States Flag Code sets the rule: no flag flies above the United States flag, and none takes its place to the right at the same level, meaning the viewer’s left. Two equal-height flagpoles put the United States flag on the viewer’s left, with both flags matched in size. Unequal flagpoles put the United States flag on the taller one, and a single flagpole with two flags carries the United States flag at the top. Civilians are not bound by penalty under the Flag Code, but it remains the standard institutions follow.

Buy two and they both last longer

Keep two flags and swap them monthly. That single habit will outlast three flags run to destruction, since resting fabric recovers and the fly end is spared the repeated wear of constant flying. Take the flag down ahead of severe weather, since one bad storm night can outdo six calm months. Watch the fly end rather than the center; a little stitching early saves a whole season.

For cities, counties, schools and agencies

We regularly supply state flags to cities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts run through the tax exempt page. Quantity pricing, replacement schedules, or a size that is not listed all go through the contact page.

Why buy it from us

Small and American describes this company, and we stock what we list. Every flag is made in the United States, printed with UV resistant ink, and finished to the construction described above rather than to a price target. We’d rather sell one flag that holds up than three that don’t. Free shipping on orders over twenty five dollars.