FORTISVEX Oregon State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets

A 6x10 foot flag is where a state flag stops being residential. Sixty square feet is a commercial flag on a commercial flagpole, and it is the last size finished with grommets rather than rope.

This is the Oregon state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Oregon flag specification

The Oregon flag is set out in Oregon Revised Statutes Section 186.010, with the seal at Section 186.020 and official colors of navy blue and gold. It is the obverse carries the state escutcheon in gold with 33 stars, the words State of Oregon above and 1859 below; the reverse carries a gold beaver.

Adopted February 26, 1925.

Design, colors and the seal or emblem are what this state's statute defines; a fixed size for an outdoor flag is not among them. Most of the country works the same way, and that is why manufacturers all build to the same standard sizes.

This flag reproduces the design faithfully, built to the standard outdoor sizes used across the industry and bought by the states themselves. The colors, the seal and the emblems are the part that has to be right on an outdoor flag, and they are right here.

The law that defines it, in its own words

Oregon Revised Statutes Section 186.010 reads:

(1) A state flag is adopted to be used on all occasions when the state is officially and publicly represented, with the privilege of use by all citizens upon such occasions as may be fitting and appropriate. It shall bear on one side on a navy blue field the state escutcheon in gold, supported by 33 gold stars and bearing above the escutcheon the words "State of Oregon" in gold and below the escutcheon the figures "1859" in gold, and on the other side on a navy blue field a representation of the beaver in gold. (2) The official colors of the State of Oregon are navy blue and gold.

Both the obverse and the reverse are in words.

You do not have to take our word for any of that. Read Oregon Revised Statutes Section 186.010 in full at the Oregon Legislature, and check what we sell against it.

That is the flag we build, not a rough version of it.

What is on it and what it means

The escutcheon shows mountains, an elk, a covered wagon, and the Pacific with a departing British man-of-war and an arriving American steamer, above the word The Union. The 33 stars mark Oregon as the 33rd state. The beaver is the state animal and the fur trade.

What most listings get wrong

A real Oregon flag is two flags sewn together. Any single-sided Oregon flag, with the seal showing through backwards on the reverse, is not the flag the statute describes.

It is the only state flag in the United States with a different design on each side, a distinction it shares only with the national flag of Paraguay.

Where the Oregon flag flies

Dan Kirkman's Baskin Robbins in Grants Pass flies a forty by sixty foot flag on a pole taller than a hundred and fifty feet, called by KTVL the largest flag in southern Oregon and possibly the entire state. A prior benchmark was Crater Lake Ford in Medford at a hundred and twenty five feet flying a thirty by sixty foot flag.

Fly it on Oregon’s birthday

Oregon became the 33rd state on February 14, 1859. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Oregon flag has an official reason to go up.

Order it ahead of the date and it is ready to fly that day. Every state’s birthday is listed on our state birthdays page.

Nylon or polyester in Oregon

Nylon in the sheltered Willamette Valley at Portland, Salem and Eugene. Polyester on the coast and in the Columbia River Gorge, a world class wind corridor.

At sixty square feet this is a commercial flag, and on the exposed sites above the choice of flag material is the difference between one season and three.

What you have here is the nylon, appropriate for the sheltered and moderate wind sites listed above, for any house bracket, and for anywhere the flag is brought down during storms. Two things decide it: it is light, flying on an ordinary breeze rather than going limp, and it dries fast, which is the defense against mildew in humidity. The trade is ultraviolet durability — nylon’s amide bonds break under sun, fading and weakening faster than polyester, and it loses about a tenth of its strength wet. For an exposed site on the list above, the polyester version is worth a look instead.

Here is the part usually learned the hard way, after a second purchase: nylon catches wind on days polyester simply will not move. When the flag needs to be visibly flying — a quiet morning, a holiday, a funeral, a ceremony — that argues for nylon even on a site where polyester would technically last longer. A flag that just hangs there is not doing its job either.

The benchmark institutions generally lean on comes from the American Legion: the federal government's own expectation is about ninety days for a daily sunrise-to-sunset flag, and roughly a quarter of that flying around the clock. Retailers report three to six months for nylon flown daily, four to eight months for polyester, and one to three years for occasional flying. Treat those as working estimates rather than a warranty, since exposure can shift them a great deal.

How the 6x10 Feet is built

At sixty square feet the force at the fly end outstrips anything a house flag sees, which is why the stitching steps up to six rows here instead of four.

Here is the arithmetic: 60 square feet of nylon at roughly two ounces a square yard. A thirty mile an hour wind sends the fly end moving faster than the wind itself, since the wave traveling toward the tip picks up speed as it goes — which is why the tip wears out first, and why the fly end's stitching count is the figure to check on any listing.

Two people to fold properly, and a clear patch of ground or a clean surface. Sixty square feet does not fold on a tailgate.

Each lock stitch knots into the one beside it, so a broken thread stays broken right where it snapped instead of unraveling the whole seam. 6 rows is not 6 times the strength — it is 5 backups. The heading is two inches of heavy duty white, reinforced, with two solid brass grommets and tooth washers. At this size the heading is the part under the most sustained strain.

Commercial grade nylon is the material in this flag. Light enough to catch a gentle breeze, it sheds water rather than holding onto it and dries fast, which keeps a flag from staying heavy and stressing its seams. The ink is UV resistant and field tested, since sun exposure is what determines how long the color lasts.

Why this flag is harder to make than most

This is the only genuinely double-sided state flag, which means two printed or appliqued faces and usually a light-blocking liner between them. It is heavier, costlier and slower to make than any other state flag, and there is no way around it.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Oregon flag placed 62, at 3.30 out of 10.

Will it fit my flagpole?

This size wants an in-ground flagpole between thirty and forty feet.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

The last size on grommets

Everything above this is finished with a rope sewn the full length of the heading rather than two grommets, because two points can no longer carry the load. The 6x10 foot flag sits right at that boundary, which is why it runs six rows of stitching and a two inch heading while still using grommets.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Underneath both tables is a single ratio: a flag a quarter to a third the flagpole’s height. When you land between two rows, that is a real choice, not a rounding error — smaller flies more often, bigger reads further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The quarter to a third rule holds all the way up, but above about a hundred feet the flag and the flagpole stop being two purchases and become one engineered system: the truck, the halyard, the foundation and the wind load all have to be specified together, and a flag bought without checking the flagpole rating damages the flagpole first. Several famous installations deliberately fly longer than the rule, which is a choice made with an engineer rather than from a chart.

Every size in both tables can be ordered, listed here or not. If the size you want does not appear on the website, contact us and we can still supply it.

About the back of the flag

Every printed flag looks right from one side and mirrored from the other, and that is simply how the overwhelming majority of American flags are built. Making both sides read correctly means building what is really two flags stitched together over a liner, at roughly twice the price and twice the weight. Single sided is the standard, and it is the right choice unless a state’s statute specifically requires otherwise.

Flying it with the United States flag

The United States Flag Code, Title 4, Section 7, governs this. No other flag goes above the United States flag, or to its right when on the same level, which is the viewer’s left. On two flagpoles of the same height the United States flag takes the viewer’s left and both flags should be the same size. If the flagpoles differ in height, the United States flag goes on the taller one. On a single flagpole carrying two flags the United States flag goes at the top. The Flag Code is advisory for civilians and carries no penalty, but it is the standard every institution follows.

Buy two and they both last longer

Keep two flags and swap them monthly. That single habit will outlast three flags run to destruction, since resting fabric recovers and the fly end is spared the repeated wear of constant flying. Take the flag down ahead of severe weather, since one bad storm night can outdo six calm months. Watch the fly end rather than the center; a little stitching early saves a whole season.

For cities, counties, schools and agencies

This is a flag we sell to municipalities, school districts, fire and police departments, courthouses and state agencies as standard business. Use the tax exempt page for a tax exempt account, and the contact page for quantity orders, a replacement schedule, or a size not shown on this listing.

Why buy it from us

We run a small American company and stock the flags we sell. Each one is made in the United States, printed in UV resistant ink, and built to the construction described above instead of built to hit a lower price. One durable flag beats three that fail, in our view. Free shipping applies to orders over twenty five dollars.