FORTISVEX Idaho State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets

A 6x10 foot flag is where a state flag stops being residential. Sixty square feet is a commercial flag on a commercial flagpole, and it is the last size finished with grommets rather than rope.

This is the Idaho state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Idaho flag specification

The Idaho flag is set out in Idaho Code Section 46-801. It is the state seal on a blue field with a red and gold band reading State of Idaho. The statute describes a silk ceremonial color, five feet six inches by four feet four inches with gilt fringe, which is the pattern flag the state keeps rather than the size anyone flies outdoors.

Adopted in 1907.

Idaho Code Section 46-801 describes a silk flag five feet six inches by four feet four inches on a pike with two and a half inch gilt fringe and a twenty one inch seal. Those are the dimensions of a ceremonial parade color from 1907, not of an outdoor flag, and no manufacturer in the country stocks that size.

The reproduction here is faithful to the design, in the standard outdoor sizes used industry wide and bought by the states themselves. On an outdoor flag, correct colors, seal and emblems are what counts, and that is what you get.

The law that defines it, in its own words

Idaho Code Section 46-801, State Flag reads:

A state flag for the state of Idaho is hereby adopted, the same to be as follows: A silk flag, blue field, five (5) feet six (6) inches fly, and four (4) feet four (4) inches on pike, bordered with gilt fringe two and one-half (2 1/2) inches in width, with state seal of Idaho twenty-one (21) inches in diameter, in colors, in the center of a blue field. The words "State of Idaho" are embroidered in with block letters, two (2) inches in height on a red band three (3) inches in width by twenty-nine (29) inches in length, the band being in gold and placed about eight and one-half (8 1/2) inches from the lower border of fringe and parallel with the same.

You do not have to take our word for any of that. Read Idaho Code Section 46-801 in full at the Idaho Legislature, and check what we sell against it.

This is the flag we make. Not an approximation of it.

What is on it and what it means

The seal shows a miner and a woman representing liberty, justice and equality, and reflects mining, forestry, farming and the state’s wildlife.

What most listings get wrong

The seal on this flag is the only state seal in the country designed by a woman, Emma Edwards Green, in 1891. Almost nobody selling this flag mentions her. Note also that the words State of Idaho appear both on the red and gold band and again inside the seal itself. That is not a printing mistake, it is the flag as Idaho Code Section 46-801 specifies it.

Emma Edwards Green designed the seal in 1891. No other state seal was designed by a woman.

Where the Idaho flag flies

Idahoans obtain United States Capitol flags through the congressional delegation. Idaho Code Section 67-820 provides that when the flag is flown at half staff at the capitol for a line of duty death, the flag flown over the capitol building in honor of the deceased shall be presented to the family. The Idaho State Historical Society documents that the copper eagle atop the Capitol dome was fabricated from parts of the battleship Idaho and was re-gilded with gold leaf during the 2005 to 2010 restoration. The state flag descends from the battle flag of the First Idaho Infantry carried in the Philippines in 1899.

Fly it on Idaho’s birthday

Idaho became the 43rd state on July 3, 1890. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Idaho flag has an official reason to go up.

Order ahead and this flag is ready for the day. The complete list of state birthdays lives on our state birthdays page.

Nylon or polyester in Idaho

Nylon in the sheltered Treasure Valley at Boise, Nampa and Meridian. Polyester across the wind exposed Snake River Plain and Magic Valley at Twin Falls, Pocatello and Idaho Falls.

For scale, the National Weather Service ultraviolet index forecast for Boise on July 23, 2026 was 10 at solar noon, in the very high band. That is the sun this flag has to survive.

At sixty square feet this is a commercial flag, and on the exposed sites above the choice of flag material is the difference between one season and three.

The nylon is what you are looking at here — the right choice for the sheltered and moderate wind sites named above, for a house bracket, and for anywhere the flag comes down ahead of storms. Two things settle it. It is light enough to fly on an ordinary yard’s breeze rather than sag, and it dries fast, fighting mildew in humid conditions. What it gives up is resistance to ultraviolet — nylon’s amide bonds break under sun, costing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. If the site is one of the exposed ones above, the polyester version fits better.

This is the detail people usually only figure out after buying twice: nylon will fly on a day too calm for polyester to move at all. If flying on a still morning, a holiday, at a funeral, or at a ceremony matters to you, that is reason enough to choose nylon even where polyester would survive longer. A motionless flag fails at its purpose regardless of how durable it is.

Institutions commonly cite the American Legion’s figure: the federal government expects about ninety days from a flag flown daily sunrise to sunset, and roughly a quarter of that flown around the clock. On the ground, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for occasional flying. Take these as working estimates, not warranties — exposure can move them a long way in either direction.

How the 6x10 Feet is built

Six rows of lock stitching replace four at this size, because sixty square feet generates far more force at the fly end than any house flag experiences. Four rows would not hold.

Here is the arithmetic: 60 square feet of nylon at roughly two ounces a square yard. A thirty mile an hour wind sends the fly end moving faster than the wind itself, since the wave traveling toward the tip picks up speed as it goes — which is why the tip wears out first, and why the fly end's stitching count is the figure to check on any listing.

Two people and a clean, open surface are what this size needs for a proper fold. A tailgate will not do at sixty square feet.

With lock stitching, every stitch knots into its neighbor, so damage stays contained at the break instead of running down the seam. Read 6 rows not as 6 times the strength but as 5 backups. The heading is two inches of heavy duty white, reinforced, with two solid brass grommets and tooth washers. At this size the heading is the part under the most sustained strain.

This flag is commercial grade nylon, light enough to move in a gentle breeze, and it sheds water instead of soaking it up, drying fast — which matters, since a wet flag is a heavy flag that works its own seams harder. UV resistant, field tested ink is what stands between the flag and the sun, since sun is what fades a flag over time.

Why this flag is harder to make than most

A highly detailed painterly seal with two human figures. This is among the most expensive state flags to reproduce accurately and the fine detail is what separates a good one from a cheap one.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Idaho flag placed 64, at 3.17 out of 10.

Will it fit my flagpole?

Thirty to forty feet of in-ground flagpole is the right pairing for this size.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

The last size on grommets

This is the boundary: everything larger switches to a full-length sewn rope because two grommets cannot hold the load. The 6x10 foot flag runs six rows of stitching and a two inch heading while staying just inside the grommet range.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Both tables follow the same logic. A flagpole reads best with a flag whose length falls between a quarter and a third of its height. Where a size could go either way, smaller means more flying days and a longer life, bigger means more visibility at range.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The quarter to a third rule holds all the way up, but above about a hundred feet the flag and the flagpole stop being two purchases and become one engineered system: the truck, the halyard, the foundation and the wind load all have to be specified together, and a flag bought without checking the flagpole rating damages the flagpole first. Several famous installations deliberately fly longer than the rule, which is a choice made with an engineer rather than from a chart.

Every size in both tables can be ordered, listed here or not. If the size you want does not appear on the website, contact us and we can still supply it.

About the back of the flag

A printed flag's reverse face is a mirror image of the front, and that is standard, not a fault — it describes most of the flags flown across the country. Double sided construction, which reads correctly from either face, sews two flags together with a liner and roughly doubles both weight and price. Single sided remains standard, and correct, unless a state's statute specifically calls for double sided.

Flying it with the United States flag

The United States Flag Code, Title 4, Section 7, governs this. No other flag goes above the United States flag, or to its right when on the same level, which is the viewer’s left. On two flagpoles of the same height the United States flag takes the viewer’s left and both flags should be the same size. If the flagpoles differ in height, the United States flag goes on the taller one. On a single flagpole carrying two flags the United States flag goes at the top. The Flag Code is advisory for civilians and carries no penalty, but it is the standard every institution follows.

Buy two and they both last longer

Alternate two flags on a monthly schedule and you will get more life from both than from three flags flown until they wear out, because resting fabric recovers and the fly end stops absorbing the same repeated stress. A severe storm is the one condition worth taking the flag down for; it can do more damage in a night than six calm months. The fly end frays first, not the center, and stitching it early adds a season.

For cities, counties, schools and agencies

State flags go out to municipalities, school districts, fire and police departments, courthouses and state agencies as a matter of course. Tax exempt purchasing runs through the tax exempt page, and anything involving quantity, a replacement schedule or a size we do not list goes through the contact page.

Why buy it from us

We are a small company based in America, and we keep in stock what we sell. Every flag is made domestically, printed in UV resistant ink, and finished to the construction described above rather than scaled down to a price. Selling a flag that lasts matters more to us than selling three that don’t. Orders over twenty five dollars ship free.