FORTISVEX Texas State Flag 4x6 Feet Polyester - Made in USA Lone Star Flag with Brass Grommets

For an in-ground flagpole on an open lot — where nylon flies well but does not last — this polyester 4x6 foot flag is the fix. Heavier for longer life, and nothing more complicated than that.

This is the Texas state flag at 4x6 Feet (24 square feet) in polyester, made in the United States and finished with brass grommets.

Built to the Texas flag specification

The Texas flag is set out in Texas Government Code Chapter 3100, at a two to three proportion, with the statute giving precise star geometry. It is a blue vertical hoist stripe one third the length carrying a white five-pointed star, with white over red horizontal stripes.

This was the 1839 national flag of the Republic of Texas, drawn by Peter Krag and approved by President Lamar January 25, 1839; it became the state flag at annexation in 1845 and was re-adopted August 31, 1933 after a period with no active flag statute.

Texas is precise about proportion rather than size. Government Code Chapter 3100 requires a width to length ratio of two to three, which a 4x6 foot flag, an 8x12 foot flag and a 10x15 foot flag all match exactly. A 3x5 foot flag is a three to five ratio and is therefore slightly deeper than the statute describes.

This flag reproduces the design faithfully, built to the standard outdoor sizes used across the industry and bought by the states themselves. The colors, the seal and the emblems are the part that has to be right on an outdoor flag, and they are right here.

The law that defines it, in its own words

Texas Government Code Section 3100.002, Description: In General reads:

(a) The state flag is a rectangle that: (1) has a width to length ratio of two to three; and (2) contains: (A) one blue vertical stripe that has a width equal to one-third the length of the flag; (B) two equal horizontal stripes, the upper stripe white, the lower stripe red, each having a length equal to two-thirds the length of the flag; and (C) one white, regular five-pointed star: (i) located in the center of the blue stripe; (ii) oriented so that one point faces upward; and (iii) sized so that the diameter of a circle passing through the five points of the star is equal to three-fourths the width of the blue stripe. (b) The red and blue of the state flag are: (1) the same colors used in the United States flag; and (2) defined as numbers 193 (red) and 281 (dark blue) of the Pantone Matching System. (c) The red, white, and blue of the state flag represent, respectively, bravery, purity, and loyalty.

Section 3100.001 separately states that the state flag is the 1839 national flag of the Republic of Texas.

You do not have to take our word for any of that. Read Texas Government Code Section 3100.002 in full at the Texas Legislature, and check what we sell against it.

This is the actual flag we manufacture, not an approximation.

What is on it and what it means

The lone star stands for Texas unity, one for God, State and Country. Chapter 3100 assigns the colors directly: blue is loyalty, white is purity, red is bravery.

Worth knowing about this flag

For most of the late nineteenth and early twentieth century Texas had no flag statute in force. The 1933 act put the Lone Star Flag back into law.

With Hawaii, it is one of only two state flags that previously served as the flag of a sovereign nation.

Where the Texas flag flies

The original Battle Flag of San Jacinto has hung in the Texas House of Representatives at the State Capitol in Austin since 1933, with a reproduction displayed when the House is not in session to protect the fragile original. The World's Largest Texas Flag, one hundred by one hundred and fifty feet, was made by Dixie Flag and Banner of San Antonio and is unfurled at Longhorns football games.

Fly it on Texas’s birthday

Texas became the 28th state on December 29, 1845. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Texas flag has an official reason to go up.

Get it now so it is flying on the day itself. See every state’s birthday on our state birthdays page.

Nylon or polyester in Texas

Polyester across the wind and ultraviolet Panhandle and West. Amarillo at 13.5 and Lubbock at 12.4 miles per hour are among the very windiest American stations, and El Paso for ultraviolet. Polyester also on the Gulf Coast at Houston and Corpus Christi. Nylon acceptable in the sheltered central metros at Austin, San Antonio and the Dallas interior.

Twenty four square feet is where wind load starts to matter in earnest, and the verdict above carries more weight here than on a standard house flag.

This is two-ply polyester, chosen for the exposed, windy, coastal and high sun sites above, and for a flagpole that flies around the clock. The fiber makes the case: ester bonds resist ultraviolet where nylon’s amide bonds break down, so strength and color hold longer under sun. It takes on almost no water, so wet strength equals dry strength, salt sheds instead of soaking in, and less water means less to freeze. The open weave lets high speed wind pass through rather than fight the fabric, which is why it outlasts nylon on exposed poles. What it costs is calm-day flight — heavier, it hangs on still afternoons while nylon keeps moving. A sheltered site will get more flying days from the nylon version.

One more thing usually learned after buying the wrong material once: changing a flag twice a year on a tall pole is not just the cost of the flag. It is the ladder trip, the halyard, the time, and on a commercial site, somebody’s paid hour. The heavier material costs more upfront and eliminates that expense. On an exposed flagpole, this flag is the cheaper option over three years, even though it costs more today.

Most institutions work from the same benchmark, reported by the American Legion: the United States government's expectation is roughly ninety days for a flag flown daily sunrise to sunset, and about a quarter of that for one flown around the clock. In practice, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for a flag flown only on occasions. These are working numbers, not a guarantee, and exposure can move them substantially either way.

How the 4x6 Feet is built

A 4x6 foot flag carries well over half again the area of a 3x5 foot flag, so it catches proportionally more wind and the fly end works harder for it. Four rows of lock stitching, and it needs all four.

Work the numbers and you get 24 square feet of two-ply spun polyester at roughly four ounces a square yard. At thirty miles an hour, the fly end actually outpaces the wind, because the wave running to the tip accelerates along the way — the reason the tip fails first, and the reason fly-end stitching count is the number that matters.

A one person job, technically, but the first windy day taking it down alone will make the size difference clear. Bring it in ahead of weather, not during it.

With lock stitching, every stitch knots into its neighbor, so damage stays contained at the break instead of running down the seam. Read 4 rows not as 4 times the strength but as 3 backups. The heading is heavy duty white and reinforced, an inch and a half wide, with two solid brass grommets and tooth washers. At twenty four square feet the load on those two points is real.

The material is two-ply spun polyester, built for punishment. Woven open, it lets wind pass through rather than resisting it, it stays just as strong wet as dry, and it holds its color under strong sun far longer. The honest trade off is weight — it needs more wind to fly, and it costs more.

A design that reproduces cleanly

Three colors and one star. It is among the cheapest state flags to build properly and among the longest lived, because there is no fine detail to fail.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Texas flag placed 2, at 8.13 out of 10.

Will it fit my flagpole?

An in-ground flagpole between eighteen and twenty five feet is the right fit; a six foot house bracket will leave it dragging and wrapping.

Questions about the 4x6 Feet

What flagpole does a 4x6 foot flag need? An in-ground flagpole of eighteen to twenty five feet. It is too large for a standard house bracket, which is the honest reason to choose it.

Is a 4x6 foot flag worth it over a 3x5 foot flag? Only if the flagpole is tall enough. On a twenty foot flagpole a 3x5 foot flag looks lost and a 4x6 foot flag fills it. On a six foot bracket the 4x6 foot flag will wrap.

Can I fly a 4x6 foot state flag with a 4x6 foot United States flag? Yes, and on two flagpoles of equal height that is the correct pairing, with the United States flag to the viewer’s left.

The size where the flag material starts to decide

With half again the area of a 3x5 foot flag, a 4x6 Feet catches proportionally more wind — the first size where nylon versus polyester genuinely changes how many flags you replace in a year.

Specifications

• Size: 4x6 Feet
• Area: 24 square feet
• Material: 100 percent two-ply spun polyester
• Fly end: 4 rows of lock stitching
• Heading: heavy duty white, reinforced, 1-1/2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

There is one number behind both tables. A flag reads right when its length is somewhere between a quarter and a third of the flagpole it is on. If your flagpole puts you between two sizes, go smaller for a flag that flies more and lasts longer, or bigger for one that carries further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The proportion still applies past a hundred feet, but the decision changes character: the flagpole, the truck, the halyard, the foundation and the wind load stop being separate line items and become one engineered whole, and ordering a flag without confirming the flagpole rating puts the flagpole at risk first. A few famous flags fly deliberately larger than the rule suggests, and all of them do it with engineering behind the choice.

What is on the website is not the limit of what we carry. Any size in the tables above can be ordered, listed or not.

About the back of the flag

The back of a printed flag shows the design reversed, not missing. That is true of almost every flag in the country, and it is normal rather than a flaw. Getting both sides to read correctly means sewing two flags together with a liner between them, which roughly doubles the cost and the weight. Single sided is standard practice, and the right choice unless a particular state’s law says otherwise.

Flying it with the United States flag

This is governed by the United States Flag Code, Title 4, Section 7: the United States flag always outranks every other flag in position, never displayed below it or to its right at the same level — right from the viewer’s side, that is. Two flagpoles of equal height place the United States flag at the viewer’s left with both flags the same size; if the poles differ in height, it goes on the taller pole; on one pole flying two flags, it sits at the top. The Flag Code carries no penalty for private citizens, but institutions treat it as the standard.

Buy two and they both last longer

One flag flown month after month wears faster at the same point every time; two flags rotated monthly outlast three run to failure, because rest lets fabric recover. Bring the flag in ahead of severe weather — a hard storm overnight can outdo six normal months. And check the fly end first, since that is where fraying starts, and a small stitch repair there is worth a full extra season.

For cities, counties, schools and agencies

Municipalities, school districts, fire and police departments, courthouses and state agencies all buy state flags from us regularly. The tax exempt page handles tax exempt accounts, and the contact page is the route for quantity orders, replacement schedules or a size not shown here.

Why buy it from us

We are a small, American-based company that stocks what it lists. Every flag is made in the United States, uses UV resistant ink, and is finished to the standard described above rather than cut down to hit a price. One flag that lasts is worth more to us than three that do not. Free shipping applies over twenty five dollars.