FORTISVEX Texas State Flag 6x10 Feet Polyester - Made in USA Lone Star Flag with Brass Grommets

This is the last grommet-finished size, sixty square feet of the heavy polyester material, and on a windy commercial site it will outlast a nylon equivalent significantly.

This is the Texas state flag at 6x10 Feet (60 square feet) in polyester, made in the United States and finished with brass grommets.

Built to the Texas flag specification

The Texas flag is set out in Texas Government Code Chapter 3100, at a two to three proportion, with the statute giving precise star geometry. It is a blue vertical hoist stripe one third the length carrying a white five-pointed star, with white over red horizontal stripes.

This was the 1839 national flag of the Republic of Texas, drawn by Peter Krag and approved by President Lamar January 25, 1839; it became the state flag at annexation in 1845 and was re-adopted August 31, 1933 after a period with no active flag statute.

Texas is precise about proportion rather than size. Government Code Chapter 3100 requires a width to length ratio of two to three, which a 4x6 foot flag, an 8x12 foot flag and a 10x15 foot flag all match exactly. A 3x5 foot flag is a three to five ratio and is therefore slightly deeper than the statute describes.

We build a faithful reproduction of that design at the standard outdoor sizes the industry uses, the same sizes states order for themselves. Correct colors, seal and emblems are what an outdoor flag has to get right, and that is what this one gets right.

The law that defines it, in its own words

Texas Government Code Section 3100.002, Description: In General reads:

(a) The state flag is a rectangle that: (1) has a width to length ratio of two to three; and (2) contains: (A) one blue vertical stripe that has a width equal to one-third the length of the flag; (B) two equal horizontal stripes, the upper stripe white, the lower stripe red, each having a length equal to two-thirds the length of the flag; and (C) one white, regular five-pointed star: (i) located in the center of the blue stripe; (ii) oriented so that one point faces upward; and (iii) sized so that the diameter of a circle passing through the five points of the star is equal to three-fourths the width of the blue stripe. (b) The red and blue of the state flag are: (1) the same colors used in the United States flag; and (2) defined as numbers 193 (red) and 281 (dark blue) of the Pantone Matching System. (c) The red, white, and blue of the state flag represent, respectively, bravery, purity, and loyalty.

Section 3100.001 separately states that the state flag is the 1839 national flag of the Republic of Texas.

You do not have to take our word for any of that. Read Texas Government Code Section 3100.002 in full at the Texas Legislature, and check what we sell against it.

That is the flag as we build it. Nothing about it is approximate.

What is on it and what it means

The lone star stands for Texas unity, one for God, State and Country. Chapter 3100 assigns the colors directly: blue is loyalty, white is purity, red is bravery.

Worth knowing about this flag

For most of the late nineteenth and early twentieth century Texas had no flag statute in force. The 1933 act put the Lone Star Flag back into law.

With Hawaii, it is one of only two state flags that previously served as the flag of a sovereign nation.

Where the Texas flag flies

The original Battle Flag of San Jacinto has hung in the Texas House of Representatives at the State Capitol in Austin since 1933, with a reproduction displayed when the House is not in session to protect the fragile original. The World's Largest Texas Flag, one hundred by one hundred and fifty feet, was made by Dixie Flag and Banner of San Antonio and is unfurled at Longhorns football games.

Fly it on Texas’s birthday

Texas became the 28th state on December 29, 1845. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Texas flag has an official reason to go up.

Have it on hand before the date arrives and it is on the flagpole in time. The full state-by-state list is on our state birthdays page.

Nylon or polyester in Texas

Polyester across the wind and ultraviolet Panhandle and West. Amarillo at 13.5 and Lubbock at 12.4 miles per hour are among the very windiest American stations, and El Paso for ultraviolet. Polyester also on the Gulf Coast at Houston and Corpus Christi. Nylon acceptable in the sheltered central metros at Austin, San Antonio and the Dallas interior.

This is a commercial flag at sixty square feet, and on the exposed sites named above, material choice separates a one-season flag from a three-season one.

This is the two-ply polyester listing, suited to the exposed, windy, coastal and high sun sites named above, and to a flagpole flown around the clock. The reason is in the fiber itself: polyester’s ester bonds resist ultraviolet, unlike nylon’s amide bonds, so color and strength hold longer under sun. Water is barely absorbed, so it is as strong wet as dry, salt sheds off rather than soaking in, and there is less to freeze. Its open weave passes fast wind through the fabric, which is why it beats nylon on exposed poles. It costs you calm-day movement — heavier, it hangs still on quiet afternoons where nylon would keep moving. A sheltered site is where the nylon version flies more often.

Most people only learn this after buying twice: replacing a flag every six months on a tall pole is not just about the flag’s price. There is the ladder, the halyard work, the time, and on a commercial site, someone’s paid hour on top. The heavier material costs more once and avoids repeating all of that. Over three years on an exposed flagpole, it works out cheaper, even though it costs more up front.

The benchmark institutions generally lean on comes from the American Legion: the federal government's own expectation is about ninety days for a daily sunrise-to-sunset flag, and roughly a quarter of that flying around the clock. Retailers report three to six months for nylon flown daily, four to eight months for polyester, and one to three years for occasional flying. Treat those as working estimates rather than a warranty, since exposure can shift them a great deal.

How the 6x10 Feet is built

Four rows of stitching is enough for a house flag; sixty square feet is not a house flag, and the fly end needs six rows to handle the force it actually generates.

Here is the arithmetic: 60 square feet of two-ply spun polyester at roughly four ounces a square yard. A thirty mile an hour wind sends the fly end moving faster than the wind itself, since the wave traveling toward the tip picks up speed as it goes — which is why the tip wears out first, and why the fly end's stitching count is the figure to check on any listing.

Proper folding at this size needs two people and clear ground. Sixty square feet is too much fabric for a tailgate fold.

With lock stitching, every stitch knots into its neighbor, so damage stays contained at the break instead of running down the seam. Read 6 rows not as 6 times the strength but as 5 backups. At sixty square feet, the heading takes the most sustained strain of any part of the flag, which is why it runs two inches of reinforced heavy duty white with brass grommets and tooth washers.

Two-ply spun polyester, the heavier material, is what this flag is built from. Its open weave lets wind pass through instead of fighting it, it keeps its strength when wet, and it resists fading longer under strong sun. The trade off is real: extra weight means it needs more wind to fly, and it costs more up front.

A design that reproduces cleanly

Three colors and one star. It is among the cheapest state flags to build properly and among the longest lived, because there is no fine detail to fail.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Texas flag placed 2, at 8.13 out of 10.

Will it fit my flagpole?

It suits an in-ground flagpole of thirty to forty feet.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

Grommets on the heavy material

Sixty square feet of the heavy material puts genuine load on two brass grommets, answered here with a two inch heading and six rows at the fly end. Beyond this size, rope takes over from grommets.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent two-ply spun polyester
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

The proportion that makes both tables work is simple: length equal to roughly a quarter to a third of the flagpole’s height. Sitting between two sizes is common, and the choice there is really a trade between a flag that flies often and one that is seen from a distance.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The rule keeps holding above a hundred feet of flagpole, but the buying decision does not stay simple: the flag, the truck, the halyard, the foundation and the wind load now have to be specified as one engineered system, and a flag chosen without checking the flagpole rating puts the pole at risk before the flag. Some of the most recognizable flags in the country deliberately run larger than the rule, always with an engineer behind that call.

What is on the website is not the limit of what we carry. Any size in the tables above can be ordered, listed or not.

About the back of the flag

The reverse of a printed flag mirrors the front, which is ordinary and true of nearly every flag in the country. To have both faces read correctly requires a double sided construction: two flags joined with a liner in between, at about twice the material and twice the price. Single sided is the industry standard, and the sensible pick unless a state’s statute says otherwise.

Flying it with the United States flag

Title 4, Section 7 of the Flag Code is the source for this. The United States flag is never subordinate in position — nothing flies above it, and nothing takes its place at the viewer’s left when flags are level with each other. On matched flagpoles, the United States flag takes the viewer’s left and the flags should be sized the same; on unequal flagpoles, it goes on the taller one; and on a single pole flying two flags, it goes at the top. There is no penalty for civilians who do not follow the Code, but institutions treat it as the standard regardless.

Buy two and they both last longer

Buy two flags and swap them every month. That habit alone outlasts three flags flown into the ground, since the material recovers while resting and the fly end is not repeatedly stressed in the same place. Take the flag down for real storms; overnight wind damage can exceed six months of ordinary wear. Inspect the fly end rather than the middle, and a few minutes of repair stitching when fraying starts buys another season.

For cities, counties, schools and agencies

We regularly supply state flags to cities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts run through the tax exempt page. Quantity pricing, replacement schedules, or a size that is not listed all go through the contact page.

Why buy it from us

We are a small, American-based company that stocks what it lists. Every flag is made in the United States, uses UV resistant ink, and is finished to the standard described above rather than cut down to hit a price. One flag that lasts is worth more to us than three that do not. Free shipping applies over twenty five dollars.