FORTISVEX Texas State Flag 3x5 Feet Nylon - Made in USA Lone Star Flag with Brass Grommets

When most people picture a flag, this is the size they mean. It fits the bracket that already came with the house, and it is the single most replaced size in the country.

This is the Texas state flag at 3x5 Feet (15 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Texas flag specification

The Texas flag is set out in Texas Government Code Chapter 3100, at a two to three proportion, with the statute giving precise star geometry. It is a blue vertical hoist stripe one third the length carrying a white five-pointed star, with white over red horizontal stripes.

This was the 1839 national flag of the Republic of Texas, drawn by Peter Krag and approved by President Lamar January 25, 1839; it became the state flag at annexation in 1845 and was re-adopted August 31, 1933 after a period with no active flag statute.

Texas is precise about proportion rather than size. Government Code Chapter 3100 requires a width to length ratio of two to three, which a 4x6 foot flag, an 8x12 foot flag and a 10x15 foot flag all match exactly. A 3x5 foot flag is a three to five ratio and is therefore slightly deeper than the statute describes.

We reproduce that design faithfully, in the standard outdoor flag sizes the whole industry uses and that the states themselves buy. What matters on an outdoor flag is that the colors, the seal and the emblems are right, and they are.

The law that defines it, in its own words

Texas Government Code Section 3100.002, Description: In General reads:

(a) The state flag is a rectangle that: (1) has a width to length ratio of two to three; and (2) contains: (A) one blue vertical stripe that has a width equal to one-third the length of the flag; (B) two equal horizontal stripes, the upper stripe white, the lower stripe red, each having a length equal to two-thirds the length of the flag; and (C) one white, regular five-pointed star: (i) located in the center of the blue stripe; (ii) oriented so that one point faces upward; and (iii) sized so that the diameter of a circle passing through the five points of the star is equal to three-fourths the width of the blue stripe. (b) The red and blue of the state flag are: (1) the same colors used in the United States flag; and (2) defined as numbers 193 (red) and 281 (dark blue) of the Pantone Matching System. (c) The red, white, and blue of the state flag represent, respectively, bravery, purity, and loyalty.

Section 3100.001 separately states that the state flag is the 1839 national flag of the Republic of Texas.

You do not have to take our word for any of that. Read Texas Government Code Section 3100.002 in full at the Texas Legislature, and check what we sell against it.

This is the actual flag we manufacture, not an approximation.

What is on it and what it means

The lone star stands for Texas unity, one for God, State and Country. Chapter 3100 assigns the colors directly: blue is loyalty, white is purity, red is bravery.

Worth knowing about this flag

For most of the late nineteenth and early twentieth century Texas had no flag statute in force. The 1933 act put the Lone Star Flag back into law.

With Hawaii, it is one of only two state flags that previously served as the flag of a sovereign nation.

Where the Texas flag flies

The original Battle Flag of San Jacinto has hung in the Texas House of Representatives at the State Capitol in Austin since 1933, with a reproduction displayed when the House is not in session to protect the fragile original. The World's Largest Texas Flag, one hundred by one hundred and fifty feet, was made by Dixie Flag and Banner of San Antonio and is unfurled at Longhorns football games.

Fly it on Texas’s birthday

Texas became the 28th state on December 29, 1845. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Texas flag has an official reason to go up.

Buy it now and it is on the flagpole for the day. The full list of state birthdays is on our state birthdays page.

Nylon or polyester in Texas

Polyester across the wind and ultraviolet Panhandle and West. Amarillo at 13.5 and Lubbock at 12.4 miles per hour are among the very windiest American stations, and El Paso for ultraviolet. Polyester also on the Gulf Coast at Houston and Corpus Christi. Nylon acceptable in the sheltered central metros at Austin, San Antonio and the Dallas interior.

Fifteen square feet, a house flag: here the material decides two things — whether it moves on a light-wind day, and how quickly it dries out after rain.

This is the nylon listing, suited to the sheltered and moderate wind sites named above, to any house bracket, and to anywhere you bring the flag in during storms. Two factors drive that choice. Nylon is light, catching the breeze most yards actually get instead of hanging still, and it dries quickly, which is what keeps mildew at bay in humid air. The cost is ultraviolet life: nylon’s amide bonds absorb and break under ultraviolet exposure, fading faster than polyester, and it loses about a tenth of its strength wet. On one of the exposed sites named above, look instead at the polyester version.

The part most buyers learn only the second time around: nylon flies in wind too light to move polyester. When it matters that the flag is actually moving — a still morning, a holiday, a funeral, a ceremony — that favors nylon even somewhere polyester would last longer. A flag that hangs motionless is not doing its job either, however durable it is.

The figure most institutions use is from the American Legion, citing the United States government's expectation of about ninety days for a flag flown daily from sunrise to sunset, and roughly a quarter of that around the clock. Retailers see three to six months in practice for nylon flown daily, four to eight for polyester, and one to three years when flown occasionally. These are practical figures, not a guarantee, and real-world exposure shifts them considerably.

How the 3x5 Feet is built

Most 3x5 foot flags fail at the fly end early, because this size is bought on price more than any other. The difference between a season and three seasons is four rows of lock stitching there.

Here is the arithmetic: 15 square feet of nylon at roughly two ounces a square yard. A thirty mile an hour wind sends the fly end moving faster than the wind itself, since the wave traveling toward the tip picks up speed as it goes — which is why the tip wears out first, and why the fly end's stitching count is the figure to check on any listing.

Raising or lowering this size is a one person task, and it folds to fit a drawer. Rotating two flags monthly is a minute of effort, no more, at 3x5 Feet.

With lock stitching, every stitch knots into its neighbor, so damage stays contained at the break instead of running down the seam. Read 4 rows not as 4 times the strength but as 3 backups. An inch and a half wide, heavy duty white and reinforced, this heading carries two solid brass grommets. Fifteen square feet is enough sail area to work them hard in any real wind.

Commercial grade nylon is the material in this flag. Light enough to catch a gentle breeze, it sheds water rather than holding onto it and dries fast, which keeps a flag from staying heavy and stressing its seams. The ink is UV resistant and field tested, since sun exposure is what determines how long the color lasts.

A design that reproduces cleanly

Three colors and one star. It is among the cheapest state flags to build properly and among the longest lived, because there is no fine detail to fail.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Texas flag placed 2, at 8.13 out of 10.

Will it fit my flagpole?

A five or six foot house bracket or a fifteen to twenty foot in-ground flagpole both suit this size — the most common residential pairing in the country, and this is the size built for it.

Questions about the 3x5 Feet

What size flagpole does a 3x5 foot flag need? A six foot house bracket, or an in-ground flagpole of fifteen to twenty feet. It is the most common residential pairing in the country.

How long does a 3x5 foot nylon flag last outside? The federal working figure is about ninety days for a flag flown daily from sunrise to sunset, and about a quarter of that flown around the clock. Retailers commonly see three to six months in daily use and one to three years flown on occasions only.

Is this flag printed or sewn? The design is printed in UV resistant ink on one side and reads through in reverse on the back, which is how nearly every state flag sold in the country is made. The construction, the heading, the stitching and the grommets are sewn.

Why this size gets replaced most

It is not that the 3x5 foot flag is weaker. It is that it is the size sold on price, which means most of them are built to a price. A cheap 3x5 foot flag with one or two rows of stitching on the fly end will fray inside a season and be six inches shorter by the end of the next one. The construction is the whole difference.

Specifications

• Size: 3x5 Feet
• Area: 15 square feet
• Material: 100 percent nylon
• Fly end: 4 rows of lock stitching
• Heading: heavy duty white, reinforced, 1-1/2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

There is one number behind both tables. A flag reads right when its length is somewhere between a quarter and a third of the flagpole it is on. If your flagpole puts you between two sizes, go smaller for a flag that flies more and lasts longer, or bigger for one that carries further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The rule keeps holding above a hundred feet of flagpole, but the buying decision does not stay simple: the flag, the truck, the halyard, the foundation and the wind load now have to be specified as one engineered system, and a flag chosen without checking the flagpole rating puts the pole at risk before the flag. Some of the most recognizable flags in the country deliberately run larger than the rule, always with an engineer behind that call.

We supply the whole range shown above, whether or not a given size currently has its own listing on the site. Ask if you do not see it.

About the back of the flag

Hold a printed flag up to the light and the reverse side shows the design in mirror image. That is not a defect — it is how nearly every flag flown in America is made. A flag correct on both sides is a double sided flag, two flags sewn together around a liner, and it runs roughly double the price and double the weight. Unless a state’s own statute calls for it, single sided is standard and it is the right call.

Flying it with the United States flag

Title 4, Section 7 of the Flag Code is the source for this. The United States flag is never subordinate in position — nothing flies above it, and nothing takes its place at the viewer’s left when flags are level with each other. On matched flagpoles, the United States flag takes the viewer’s left and the flags should be sized the same; on unequal flagpoles, it goes on the taller one; and on a single pole flying two flags, it goes at the top. There is no penalty for civilians who do not follow the Code, but institutions treat it as the standard regardless.

Buy two and they both last longer

Buy two flags and swap them every month. That habit alone outlasts three flags flown into the ground, since the material recovers while resting and the fly end is not repeatedly stressed in the same place. Take the flag down for real storms; overnight wind damage can exceed six months of ordinary wear. Inspect the fly end rather than the middle, and a few minutes of repair stitching when fraying starts buys another season.

For cities, counties, schools and agencies

We supply state flags to municipalities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts are handled through the tax exempt page. For quantities, replacement schedules or sizes not listed, use the contact page.

Why buy it from us

We are a small American company and we stock what we sell. Every flag here is made in the United States, printed in UV resistant ink, and finished to the construction described above rather than to a price point. We would rather sell you one flag that lasts than three that do not. Free shipping on orders over twenty five dollars.