Delaware 12x18 Feet Nylon State Flag Made in USA

Two hundred and sixteen square feet puts a 12x18 foot flag in major-installation territory — civic sites, memorial grounds, highway locations, anywhere the flag has to read from a long way off.

This is the Delaware state flag at 12x18 Feet (216 square feet) in nylon, made in the United States and finished with a sewn rope and plated steel thimbles.

Built to the Delaware flag specification

The Delaware flag is set out in Delaware Code, Title 29, Section 306. It is a colonial blue field with a buff diamond containing the state coat of arms, and the date December 7, 1787 set below the diamond.

The design was adopted July 24, 1913.

What is fixed by law here is the design, the colors and the seal or emblem — not a size requirement for an outdoor flag. Most states leave it the same way, which is why the whole industry has settled on the same standard sizes.

The reproduction here is faithful to the design, in the standard outdoor sizes used industry wide and bought by the states themselves. On an outdoor flag, correct colors, seal and emblems are what counts, and that is what you get.

The law that defines it, in its own words

Delaware Code, Title 29, Section 306 reads:

The design of the official state flag shall be as follows: A background of colonial blue surrounding a diamond of buff in which diamond is placed the correct coat of arms of the State in the colors prescribed by law and in accordance with § 301 of this title, with the words, "December 7, 1787," to be inscribed underneath the diamond. The official state colors, colonial blue and buff, are designated by the Textile Color Card Association of the United States, Inc., New York, as "arno blue" Cable No. 10663, and "golden beige" Cable No. 10781 respectively; the color shades having been determined by Colorimetric Specifications of the National Bureau of Standards, United States Department of Commerce, in Test No. 2, 1/140565, dated November 18, 1954, which is on file with the Delaware Public Archives, Dover, Delaware. The colors of the coat of arms and other elements of the state flag shall be the following: Husbandman, trousers of gray brown, shirt of red, hat and hilling hoe of brown; rifleman, suit of green, binding, bag and leggings of buff, hat of brown, powder flask and feather of gray; shield, frame of shaded yellow, top panel of orange, center panel of blue, lower panel of white, ox of red brown, grass and corn of green, wheat and branches underfoot of yellow, heraldric wreath to be blue and silver (twisted); ship under full sail to have a dark hull and white sails; date, December 7, 1787, to be white; cord and tassels to be blue and gold.

The spelling heraldric is the statute’s own. The arms themselves are defined at Section 301 of the same title.

You do not have to take our word for any of that. Read Delaware Code in full at the Delaware Code, and check what we sell against it.

This is the flag we make. Not an approximation of it.

What is on it and what it means

The colors are colonial blue and buff, Washington’s uniform colors. The date marks Delaware as the first state to ratify the Constitution. The arms carry a farmer, a rifleman, a ship, an ox, wheat and corn.

Worth knowing about this flag

The layout is genuinely unusual. Almost no other state flag sets a date outside the central device, and the buff of the diamond is frequently printed as yellow.

Where the Delaware flag flies

Delaware's senators offer only the federal program and route residents who want a Delaware flag to contact a state legislator to obtain one, rather than to fly it over Legislative Hall. The Governor maintains an official flag status page for half staff orders at state buildings. Legislative Hall is a Colonial Revival building of 1931 to 1933, with wings added in 1965 to 1970 and again in 1994.

Fly it on Delaware’s birthday

Delaware became the first state on December 7, 1787. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Delaware flag has an official reason to go up.

Buy it in time and it goes up on the day it matters. Every state’s date is on our state birthdays page.

Nylon or polyester in Delaware

Nylon in the Wilmington and Dover interior. Polyester at the coast at Rehoboth and Lewes.

At two hundred and sixteen square feet, an installation flag, any exposed site above that calls for polyester means it absolutely, with the flagpole engineered to carry it.

This listing is the nylon. It is the right choice for the sheltered and moderate wind sites named above, on any house bracket, and anywhere the flag comes down in storms. Two things decide that. Nylon is light, so it flies on the breeze most yards actually get instead of hanging limp, and it dries fast, which is what fights mildew in a humid climate. What it gives up is ultraviolet life: nylon’s amide bonds absorb ultraviolet and break, so under hard sun it loses strength and color faster than polyester, and it loses roughly a tenth of its strength while it is wet. If your site is one of the exposed ones above, look at the polyester version of this flag instead.

This is the detail people usually only figure out after buying twice: nylon will fly on a day too calm for polyester to move at all. If flying on a still morning, a holiday, at a funeral, or at a ceremony matters to you, that is reason enough to choose nylon even where polyester would survive longer. A motionless flag fails at its purpose regardless of how durable it is.

The figure most institutions use is from the American Legion, citing the United States government's expectation of about ninety days for a flag flown daily from sunrise to sunset, and roughly a quarter of that around the clock. Retailers see three to six months in practice for nylon flown daily, four to eight for polyester, and one to three years when flown occasionally. These are practical figures, not a guarantee, and real-world exposure shifts them considerably.

How the 12x18 Feet is built

Six rows of lock stitching on the fly end and zig zag stitched corners. Everything about the construction at this size exists to manage a load that would destroy a house flag in an afternoon.

The math comes to 216 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind, the fly end moves faster than the wind that is driving it, since the wave headed for the tip speeds up as it travels — which explains why the tip wears out first and why fly-end stitching count is worth checking on any listing.

Treat this as a scheduled operation rather than a quick task. Two hundred and sixteen square feet goes up and down with the site in mind, and never when the wind is already blowing.

With lock stitching, every stitch knots into its neighbor, so damage stays contained at the break instead of running down the seam. Read 6 rows not as 6 times the strength but as 5 backups. Two plated steel thimbles finish a full-length nylon rope sewn into the heading, spreading two hundred and sixteen square feet of load across the entire hoist.

Nylon, commercial grade, is what this flag is made from. It is light enough to move in a gentle breeze, sheds rather than soaks up water, and dries quickly — a wet flag is a heavier flag, harder on its own seams. The ink is UV resistant and field tested, because sun exposure is what actually fades a flag.

Why this flag is harder to make than most

Detailed arms plus dated lettering. Two elements that both need to stay legible, on a diamond that has to sit square.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Delaware flag placed 52, at 4.08 out of 10.

Will it fit my flagpole?

It suits an in-ground flagpole of sixty to eighty feet with hardware rated accordingly.

Questions about the 12x18 Feet

What size flagpole for a 12x18 foot flag? Sixty to eighty feet with hardware engineered for two hundred and sixteen square feet of load.

Who buys a 12x18 foot state flag? Civic sites, memorial grounds, highway frontages and campuses, anywhere the flag is meant to be seen from a long way off.

Does a flag this size need special care? It needs a rotation, hardware checks, and taking down in severe weather. Flown properly it lasts. Flown carelessly it does not last a season.

This size is a commitment

A flag of this size belongs on a maintenance schedule, not a set-and-forget flagpole. It needs rotation, hardware checks, and to come down before severe weather. Flown right, it lasts; flown carelessly, it fails inside a season.

Specifications

• Size: 12x18 Feet
• Area: 216 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Rope, Thimbles and Center Grommet
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Underneath both tables is a single ratio: a flag a quarter to a third the flagpole’s height. When you land between two rows, that is a real choice, not a rounding error — smaller flies more often, bigger reads further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The rule keeps holding above a hundred feet of flagpole, but the buying decision does not stay simple: the flag, the truck, the halyard, the foundation and the wind load now have to be specified as one engineered system, and a flag chosen without checking the flagpole rating puts the pole at risk before the flag. Some of the most recognizable flags in the country deliberately run larger than the rule, always with an engineer behind that call.

We supply the whole range shown above, whether or not a given size currently has its own listing on the site. Ask if you do not see it.

About the back of the flag

Every printed flag looks right from one side and mirrored from the other, and that is simply how the overwhelming majority of American flags are built. Making both sides read correctly means building what is really two flags stitched together over a liner, at roughly twice the price and twice the weight. Single sided is the standard, and it is the right choice unless a state’s statute specifically requires otherwise.

Flying it with the United States flag

This is governed by the United States Flag Code, Title 4, Section 7: the United States flag always outranks every other flag in position, never displayed below it or to its right at the same level — right from the viewer’s side, that is. Two flagpoles of equal height place the United States flag at the viewer’s left with both flags the same size; if the poles differ in height, it goes on the taller pole; on one pole flying two flags, it sits at the top. The Flag Code carries no penalty for private citizens, but institutions treat it as the standard.

Buy two and they both last longer

Keep two flags and swap them monthly. That single habit will outlast three flags run to destruction, since resting fabric recovers and the fly end is spared the repeated wear of constant flying. Take the flag down ahead of severe weather, since one bad storm night can outdo six calm months. Watch the fly end rather than the center; a little stitching early saves a whole season.

For cities, counties, schools and agencies

We regularly supply state flags to cities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts run through the tax exempt page. Quantity pricing, replacement schedules, or a size that is not listed all go through the contact page.

Why buy it from us

This company is small and American, and what is on the site is in stock. Every flag here is made in the United States, uses UV resistant ink, and is built to the construction described above rather than priced down to a cheaper build. We would rather you buy one flag that lasts than replace three that do not. Orders over twenty five dollars get free shipping.