Delaware 10x15 Feet Nylon State Flag Made in USA

A 10x15 foot flag is a large installation flag. A hundred and fifty square feet reads from a considerable distance, which is the reason to fly it, and it needs a flagpole and hardware built to match.

This is the Delaware state flag at 10x15 Feet (150 square feet) in nylon, made in the United States and finished with a sewn rope and plated steel thimbles.

Built to the Delaware flag specification

The Delaware flag is set out in Delaware Code, Title 29, Section 306. It is a colonial blue field with a buff diamond containing the state coat of arms, and the date December 7, 1787 set below the diamond.

The design was adopted July 24, 1913.

The law governing this flag addresses design, colors and the seal or emblem, but leaves overall size unspecified for a modern outdoor flag. That is typical across most states, which is why the industry has converged on the same standard sizes.

The design here is reproduced faithfully, at the standard outdoor sizes the whole industry works in and that states buy for themselves. What actually matters on a flag flown outdoors is that the colors, the seal and the emblems are correct, and they are.

The law that defines it, in its own words

Delaware Code, Title 29, Section 306 reads:

The design of the official state flag shall be as follows: A background of colonial blue surrounding a diamond of buff in which diamond is placed the correct coat of arms of the State in the colors prescribed by law and in accordance with § 301 of this title, with the words, "December 7, 1787," to be inscribed underneath the diamond. The official state colors, colonial blue and buff, are designated by the Textile Color Card Association of the United States, Inc., New York, as "arno blue" Cable No. 10663, and "golden beige" Cable No. 10781 respectively; the color shades having been determined by Colorimetric Specifications of the National Bureau of Standards, United States Department of Commerce, in Test No. 2, 1/140565, dated November 18, 1954, which is on file with the Delaware Public Archives, Dover, Delaware. The colors of the coat of arms and other elements of the state flag shall be the following: Husbandman, trousers of gray brown, shirt of red, hat and hilling hoe of brown; rifleman, suit of green, binding, bag and leggings of buff, hat of brown, powder flask and feather of gray; shield, frame of shaded yellow, top panel of orange, center panel of blue, lower panel of white, ox of red brown, grass and corn of green, wheat and branches underfoot of yellow, heraldric wreath to be blue and silver (twisted); ship under full sail to have a dark hull and white sails; date, December 7, 1787, to be white; cord and tassels to be blue and gold.

The spelling heraldric is the statute’s own. The arms themselves are defined at Section 301 of the same title.

You do not have to take our word for any of that. Read Delaware Code in full at the Delaware Code, and check what we sell against it.

This is the actual flag we manufacture, not an approximation.

What is on it and what it means

The colors are colonial blue and buff, Washington’s uniform colors. The date marks Delaware as the first state to ratify the Constitution. The arms carry a farmer, a rifleman, a ship, an ox, wheat and corn.

Worth knowing about this flag

The layout is genuinely unusual. Almost no other state flag sets a date outside the central device, and the buff of the diamond is frequently printed as yellow.

Where the Delaware flag flies

Delaware's senators offer only the federal program and route residents who want a Delaware flag to contact a state legislator to obtain one, rather than to fly it over Legislative Hall. The Governor maintains an official flag status page for half staff orders at state buildings. Legislative Hall is a Colonial Revival building of 1931 to 1933, with wings added in 1965 to 1970 and again in 1994.

Fly it on Delaware’s birthday

Delaware became the first state on December 7, 1787. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Delaware flag has an official reason to go up.

Order ahead and this flag is ready for the day. The complete list of state birthdays lives on our state birthdays page.

Nylon or polyester in Delaware

Nylon in the Wilmington and Dover interior. Polyester at the coast at Rehoboth and Lewes.

At this size, a hundred and fifty square feet, nylon is not realistic on an exposed site above. Verify the flagpole and truck rating before ordering either one.

The nylon is what you are looking at here — the right choice for the sheltered and moderate wind sites named above, for a house bracket, and for anywhere the flag comes down ahead of storms. Two things settle it. It is light enough to fly on an ordinary yard’s breeze rather than sag, and it dries fast, fighting mildew in humid conditions. What it gives up is resistance to ultraviolet — nylon’s amide bonds break under sun, costing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. If the site is one of the exposed ones above, the polyester version fits better.

One more consideration, learned by most people only after a repeat purchase: a nylon flag moves in conditions where polyester hangs still. If the flag needs to actually be flying — a calm morning, a holiday, a funeral, a ceremony — that is an argument for nylon even on a site where polyester would technically outlast it. A flag that just hangs there has failed just as much as one that frays.

Institutions commonly cite the American Legion’s figure: the federal government expects about ninety days from a flag flown daily sunrise to sunset, and roughly a quarter of that flown around the clock. On the ground, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for occasional flying. Take these as working estimates, not warranties — exposure can move them a long way in either direction.

How the 10x15 Feet is built

At a hundred and fifty square feet, the wave running to the tip moves fast enough that corners take the first hit, which is why they are zig zag stitched and the fly end runs six rows.

Here is the arithmetic: 150 square feet of nylon at roughly two ounces a square yard. A thirty mile an hour wind sends the fly end moving faster than the wind itself, since the wave traveling toward the tip picks up speed as it goes — which is why the tip wears out first, and why the fly end's stitching count is the figure to check on any listing.

Plan the handling before it arrives. A hundred and fifty square feet needs two people who have agreed what they are doing, on a day that is not windy, with the halyard already sorted.

Each lock stitch knots into the one beside it, so a broken thread stays broken right where it snapped instead of unraveling the whole seam. 6 rows is not 6 times the strength — it is 5 backups. Two plated steel thimbles finish a nylon rope sewn the length of the heading. At a hundred and fifty square feet, a grommet alone has no chance of holding the full load, which is why only one reinforced grommet remains, at the center of the heading, as a secondary attachment point.

The flag material is commercial grade nylon. It is light enough to fly in a gentle breeze, it sheds water rather than holding it, and it dries fast, which matters because a flag that stays wet stays heavy and works its seams harder. The ink is UV resistant and field tested; sun is what takes a flag’s color, and the ink decides how long it holds.

Why this flag is harder to make than most

Detailed arms plus dated lettering. Two elements that both need to stay legible, on a diamond that has to sit square.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Delaware flag placed 52, at 4.08 out of 10.

Will it fit my flagpole?

This size wants an in-ground flagpole between fifty and sixty feet, matched with hardware rated for its load.

Questions about the 10x15 Feet

What size flagpole for a 10x15 foot flag? Fifty to sixty feet, and the truck and halyard must be rated for a hundred and fifty square feet in a gust.

Is a 10x15 foot flag too big for my flagpole? If the flagpole was not specified for it, yes. An oversized flag damages the flagpole before it damages itself.

How is a 10x15 foot flag shipped? Rolled where possible, folded where it must be. Creases from folding relax within days of flying.

Check the flagpole before the flag

This size, a hundred and fifty square feet, can exceed what a flagpole was built to carry. Check the flagpole and truck rating before ordering — an oversized flag damages an undersized flagpole before it damages itself.

Specifications

• Size: 10x15 Feet
• Area: 150 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Rope, Thimbles and Center Grommet
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

One rule sits under both tables: the flag should run about a quarter to a third the height of the flagpole. On the border between two rows, the smaller flag flies more and lasts longer; the larger one is the one you can see from the road.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

That same ratio keeps working past a hundred feet, but at that point the flag and the flagpole are no longer separate purchases — the truck, the halyard, the foundation and the wind load all have to be sized together, and a flag chosen without checking the flagpole first damages the pole rather than itself. A handful of well known installations deliberately run past the rule of thumb, and every one of them did it with an engineer, not a chart.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

A printed flag's reverse face is a mirror image of the front, and that is standard, not a fault — it describes most of the flags flown across the country. Double sided construction, which reads correctly from either face, sews two flags together with a liner and roughly doubles both weight and price. Single sided remains standard, and correct, unless a state's statute specifically calls for double sided.

Flying it with the United States flag

The United States Flag Code, at Title 4, Section 7, sets this out: the United States flag holds the position of honor, never below another flag and never displaced from the viewer’s left when flags fly level. With two flagpoles of matching height, the United States flag takes the viewer’s left and the flags match in size; with unequal heights, it goes on the taller pole; on a single pole carrying two flags, it is at the top. The Code has no penalty attached for civilians, but it remains the standard every institution follows.

Buy two and they both last longer

Fly one for a month, then swap. Two flags rotated monthly will outlast three flags flown to destruction, because the fabric recovers when it rests and the fly end stops taking the same abuse in the same place. Take it down in severe weather; a flag left up through a real windstorm can take more damage in one night than in six normal months. And watch the fly end rather than the middle, because a few minutes with a needle when the fraying starts buys another season.

For cities, counties, schools and agencies

Fire and police departments, school districts, courthouses, municipalities and state agencies are all regular buyers of our state flags. Tax exempt purchasing is set up through the tax exempt page, and quantities, replacement schedules or an unlisted size are handled through the contact page.

Why buy it from us

This is a small American company, and what you see listed is what we actually stock. Every flag is made in the United States, printed with UV resistant ink, and built to the construction described above, not to whatever a price point demands. Selling one flag that lasts beats selling three that fail. Orders over twenty five dollars ship free.