Texas 10x15 Feet Nylon State Flag Made in USA

This is a large installation flag: a hundred and fifty square feet, visible from a real distance, which is the whole point of choosing it. The flagpole and hardware have to be built to match.

This is the Texas state flag at 10x15 Feet (150 square feet) in nylon, made in the United States and finished with a sewn rope and plated steel thimbles.

Built to the Texas flag specification

The Texas flag is set out in Texas Government Code Chapter 3100, at a two to three proportion, with the statute giving precise star geometry. It is a blue vertical hoist stripe one third the length carrying a white five-pointed star, with white over red horizontal stripes.

This was the 1839 national flag of the Republic of Texas, drawn by Peter Krag and approved by President Lamar January 25, 1839; it became the state flag at annexation in 1845 and was re-adopted August 31, 1933 after a period with no active flag statute.

Texas is precise about proportion rather than size. Government Code Chapter 3100 requires a width to length ratio of two to three, which a 4x6 foot flag, an 8x12 foot flag and a 10x15 foot flag all match exactly. A 3x5 foot flag is a three to five ratio and is therefore slightly deeper than the statute describes.

Faithfully reproduced, that is the standard we hold this design to, at the outdoor sizes the whole industry uses and states themselves order. What an outdoor flag needs right is the color, the seal and the emblems, and this one has them right.

The law that defines it, in its own words

Texas Government Code Section 3100.002, Description: In General reads:

(a) The state flag is a rectangle that: (1) has a width to length ratio of two to three; and (2) contains: (A) one blue vertical stripe that has a width equal to one-third the length of the flag; (B) two equal horizontal stripes, the upper stripe white, the lower stripe red, each having a length equal to two-thirds the length of the flag; and (C) one white, regular five-pointed star: (i) located in the center of the blue stripe; (ii) oriented so that one point faces upward; and (iii) sized so that the diameter of a circle passing through the five points of the star is equal to three-fourths the width of the blue stripe. (b) The red and blue of the state flag are: (1) the same colors used in the United States flag; and (2) defined as numbers 193 (red) and 281 (dark blue) of the Pantone Matching System. (c) The red, white, and blue of the state flag represent, respectively, bravery, purity, and loyalty.

Section 3100.001 separately states that the state flag is the 1839 national flag of the Republic of Texas.

You do not have to take our word for any of that. Read Texas Government Code Section 3100.002 in full at the Texas Legislature, and check what we sell against it.

It is the real flag we produce, not a simplified version.

What is on it and what it means

The lone star stands for Texas unity, one for God, State and Country. Chapter 3100 assigns the colors directly: blue is loyalty, white is purity, red is bravery.

Worth knowing about this flag

For most of the late nineteenth and early twentieth century Texas had no flag statute in force. The 1933 act put the Lone Star Flag back into law.

With Hawaii, it is one of only two state flags that previously served as the flag of a sovereign nation.

Where the Texas flag flies

The original Battle Flag of San Jacinto has hung in the Texas House of Representatives at the State Capitol in Austin since 1933, with a reproduction displayed when the House is not in session to protect the fragile original. The World's Largest Texas Flag, one hundred by one hundred and fifty feet, was made by Dixie Flag and Banner of San Antonio and is unfurled at Longhorns football games.

Fly it on Texas’s birthday

Texas became the 28th state on December 29, 1845. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Texas flag has an official reason to go up.

Buy it in time and it goes up on the day it matters. Every state’s date is on our state birthdays page.

Nylon or polyester in Texas

Polyester across the wind and ultraviolet Panhandle and West. Amarillo at 13.5 and Lubbock at 12.4 miles per hour are among the very windiest American stations, and El Paso for ultraviolet. Polyester also on the Gulf Coast at Houston and Corpus Christi. Nylon acceptable in the sheltered central metros at Austin, San Antonio and the Dallas interior.

On an exposed site from the list above, a hundred and fifty square feet makes nylon a non-starter. Check the flagpole and truck rating regardless of which material you order.

This listing is nylon, right for the sheltered and moderate wind sites above, for a standard house bracket, and for anywhere you take the flag down before a storm. Two things make it the pick. It flies on the breeze most yards actually see instead of hanging flat, being light, and it dries fast, which fights mildew where humidity is high. What it sacrifices is ultraviolet resistance: nylon’s amide bonds absorb and break under sun, losing strength and color faster than polyester, plus roughly a tenth of its strength while wet. For an exposed site from the list above, the polyester version is the better choice.

One more thing that decides it, and it is the part people only learn after buying twice: a nylon flag flies on days a polyester flag will not. If the flag matters to you on a still morning, on a holiday, at a funeral, at a ceremony, that is an argument for this one even on a site where the polyester would last longer. A flag that hangs is not doing its job either.

The figure most institutions use is from the American Legion, citing the United States government's expectation of about ninety days for a flag flown daily from sunrise to sunset, and roughly a quarter of that around the clock. Retailers see three to six months in practice for nylon flown daily, four to eight for polyester, and one to three years when flown occasionally. These are practical figures, not a guarantee, and real-world exposure shifts them considerably.

How the 10x15 Feet is built

The fly end runs six rows of lock stitching with zig zag stitched corners, because at this size the tip-bound wave moves fast enough to attack the corner seams first.

The math comes to 150 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind, the fly end moves faster than the wind that is driving it, since the wave headed for the tip speeds up as it travels — which explains why the tip wears out first and why fly-end stitching count is worth checking on any listing.

Have a plan before this arrives: a hundred and fifty square feet needs two people working from an agreed plan, on a calm day, with the halyard already set up.

A lock stitch ties into the stitch next to it, so one broken thread does not unzip the whole seam — it just stops. 6 rows is not 6 times the strength; it is 5 backups. At this size a grommet would fail outright, so the heading instead carries a nylon rope its full length, finished with two plated steel thimbles.

This is commercial grade nylon: light enough to fly in a light wind, quick to shed water instead of holding it, and fast to dry, which matters because a waterlogged flag is a heavier flag putting more strain on its seams. UV resistant, field tested ink is what fights the sun, which is the real driver of color loss over time.

A design that reproduces cleanly

Three colors and one star. It is among the cheapest state flags to build properly and among the longest lived, because there is no fine detail to fail.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Texas flag placed 2, at 8.13 out of 10.

Will it fit my flagpole?

A fifty to sixty foot in-ground flagpole, with truck and halyard rated to carry it, suits this size.

Questions about the 10x15 Feet

What size flagpole for a 10x15 foot flag? Fifty to sixty feet, and the truck and halyard must be rated for a hundred and fifty square feet in a gust.

Is a 10x15 foot flag too big for my flagpole? If the flagpole was not specified for it, yes. An oversized flag damages the flagpole before it damages itself.

How is a 10x15 foot flag shipped? Rolled where possible, folded where it must be. Creases from folding relax within days of flying.

Check the flagpole before the flag

A hundred and fifty square feet can load a flagpole past what it was engineered for. Confirm the flagpole and truck rating before ordering this size — an oversized flag on an undersized pole damages the pole first, the flag second.

Specifications

• Size: 10x15 Feet
• Area: 150 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Rope and Thimbles
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

There is one number behind both tables. A flag reads right when its length is somewhere between a quarter and a third of the flagpole it is on. If your flagpole puts you between two sizes, go smaller for a flag that flies more and lasts longer, or bigger for one that carries further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Above roughly a hundred feet of flagpole, the quarter to a third guide keeps its accuracy but loses its simplicity: the flag now has to be specified alongside the truck, the halyard, the foundation and the wind load as a single system, and skipping that step is how a flagpole gets damaged rather than the flag. Several famous installations fly flags larger than the rule on purpose, with an engineer deciding it rather than a table.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

The reverse of a printed flag mirrors the front, which is ordinary and true of nearly every flag in the country. To have both faces read correctly requires a double sided construction: two flags joined with a liner in between, at about twice the material and twice the price. Single sided is the industry standard, and the sensible pick unless a state’s statute says otherwise.

Flying it with the United States flag

Section 7 of Title 4, the United States Flag Code, addresses this directly: the United States flag is never outranked in position, staying above every other flag and to the right at the same level, which reads as the viewer’s left. Same-height flagpoles put the United States flag on the viewer’s left with matching flag sizes; different heights put it on the taller pole; one flagpole with two flags puts it at the top. There is no legal penalty for civilians under the Flag Code, but it is what every institution follows anyway.

Buy two and they both last longer

Two flags, alternated month to month, beat three flags flown until they fall apart, because the material recovers on its days off and the fly end is not worked in the same place every day. Severe weather is the one time to take it down; a real windstorm can cost more in one night than six ordinary months of flying. Fraying starts at the fly end, not the middle, and a few minutes with a needle there adds a season.

For cities, counties, schools and agencies

Our state flags go to municipalities, school districts, fire and police departments, courthouses and state agencies regularly. Tax exempt purchasing is handled on the tax exempt page. For quantity, a replacement schedule, or a size outside this listing, use the contact page.

Why buy it from us

We are a small company based in America, and we keep in stock what we sell. Every flag is made domestically, printed in UV resistant ink, and finished to the construction described above rather than scaled down to a price. Selling a flag that lasts matters more to us than selling three that don’t. Orders over twenty five dollars ship free.