Valley Forge Flag

Black Rotating Ground Spike With Ball Bearing

(No reviews yet) Write a Review
Free Shipping*
4.00 LBS
Calculated at Checkout

Bulk discount rates

Below are the available bulk discount rates for each individual item when you purchase a certain amount

Buy 3 - 5 and get 3% off
Buy 6 or above and get 5% off


This Black Rotating Ground Spike with Ball Bearing are designed to work with these poles BTS9, BTM12, BTL16. Flag is sold separately. Pole is sold separately.

The flag will rotate with a light breeze due to the ball bearing pole mounts. Flag is sold separately. Pole is sold separately.

This Ground Spike requires purchasing of a pole and flag sold separately.

Price discount if purchased in cases. Each case comes with 12 Ground Spikes.

Part Number: TELGS

Made by Valley Forge Flag

Blade and Teardrop Flagpole Instructions:

Part Numbers: BTS9, BTM12, BTL16

Depending on the size of the pole that you are assembling you will have two
(BTS9), three (BTM12) or four (BTL16) pole sections. Always start with the
largest pole section. This piece is the bottom of the pole. Each section of the
pole slides into the next from largest to smallest until the pole is completely

Remove the bungee cord from the mesh pocket on the inside of the carrying
case. This is needed for flag attachment.

Slide the sleeve of the flag over the top of the pole. When you place the flag
on the pole the pole will bend to take the shape of the flag.

Loop the bungee through the leather tab on the bottom of the flag. Tighten
the bungee to provide enough tension for the flag to arch. Tie the bungee
cord to the knob located at the bottom of the pole to secure it in place.

There is a mounting hole in the bottom of these poles, which can be used
with a rotating ground spike or a crossbase with waterbag. The ground
spikes (TELGS) and crossbase with waterbag (CRW1) are not
included and must be purchased separately.

View AllClose