FORTISVEX Alabama State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets

A 6x10 foot flag is where a state flag stops being residential. Sixty square feet is a commercial flag on a commercial flagpole, and it is the last size finished with grommets rather than rope.

This is the Alabama state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Alabama flag specification

The Alabama flag is set out in Alabama Code Section 1-2-5. It is a crimson St. Andrew’s cross, a saltire, on a white field, with the bars required to be not less than six inches broad.

Adopted February 16, 1895 by Act 383, introduced by its designer, Representative John W. A. Sanford Jr.

Alabama Code Section 1-2-5 says nothing about the overall size or even the shape. The only absolute measurement in it is that the saltire bars be not less than six inches broad, which on a small flag is proportionally impossible to satisfy and has never once been enforced. The Attorney General addressed the shape question in 1987 and concluded that where the statute is silent, precedent and practice govern.

Faithfully reproduced, that is the standard we hold this design to, at the outdoor sizes the whole industry uses and states themselves order. What an outdoor flag needs right is the color, the seal and the emblems, and this one has them right.

The law that defines it, in its own words

Code of Alabama Section 1-2-5 reads:

The flag of the State of Alabama shall be a crimson cross of St. Andrew on a field of white. The bars forming the cross shall be not less than six inches broad, and must extend diagonally across the flag from side to side.

You do not have to take our word for any of that. Read Code of Alabama Section 1-2-5 in full at Justia, and check what we sell against it.

That is the flag as we build it. Nothing about it is approximate.

What is on it and what it means

The statute itself describes only a crimson saltire on white. It carries no seal and no lettering, which is why it reads clearly from a distance at every size.

What most listings get wrong

Because the statute sets a minimum bar width of six inches, a very small flag technically does not meet the legal definition. That is a curiosity rather than a problem, but it is the kind of detail nobody else on the internet mentions.

Where the Alabama flag flies

A thirty eight by twenty foot flag on a seventy foot pole at Camp Liberty in Cullman County is billed only as Cullman County's largest, not a statewide record.

Fly it on Alabama’s birthday

Alabama became the 22nd state on December 14, 1819. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Alabama flag has an official reason to go up.

Get it now so it is flying on the day itself. See every state’s birthday on our state birthdays page.

Nylon or polyester in Alabama

Nylon inland at Birmingham, Montgomery, Huntsville and Tuscaloosa. Polyester on the Gulf Coast at Mobile for salt, humidity and hurricane exposure.

Take any flag down for tornado and tropical events.

For scale, the National Weather Service ultraviolet index forecast for Mobile on July 23, 2026 was 11 at solar noon, in the extreme band. That is the sun this flag has to survive.

At sixty square feet, firmly commercial territory, the material choice on an exposed site above decides between one season and three.

The nylon is what you are looking at here — the right choice for the sheltered and moderate wind sites named above, for a house bracket, and for anywhere the flag comes down ahead of storms. Two things settle it. It is light enough to fly on an ordinary yard’s breeze rather than sag, and it dries fast, fighting mildew in humid conditions. What it gives up is resistance to ultraviolet — nylon’s amide bonds break under sun, costing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. If the site is one of the exposed ones above, the polyester version fits better.

There is one more factor, and most people only discover it after buying the wrong material once: a nylon flag moves on days a polyester flag stays limp. If it matters to you that the flag is actually flying on a still morning, a holiday, at a funeral, at a ceremony, that favors nylon even where polyester would outlast it. A flag hanging motionless has failed at its job too.

The benchmark institutions generally lean on comes from the American Legion: the federal government's own expectation is about ninety days for a daily sunrise-to-sunset flag, and roughly a quarter of that flying around the clock. Retailers report three to six months for nylon flown daily, four to eight months for polyester, and one to three years for occasional flying. Treat those as working estimates rather than a warranty, since exposure can shift them a great deal.

How the 6x10 Feet is built

Four rows of stitching is enough for a house flag; sixty square feet is not a house flag, and the fly end needs six rows to handle the force it actually generates.

Work the numbers and you get 60 square feet of nylon at roughly two ounces a square yard. At thirty miles an hour, the fly end actually outpaces the wind, because the wave running to the tip accelerates along the way — the reason the tip fails first, and the reason fly-end stitching count is the number that matters.

Proper folding at this size needs two people and clear ground. Sixty square feet is too much fabric for a tailgate fold.

A lock stitch ties into the stitch next to it, so one broken thread does not unzip the whole seam — it just stops. 6 rows is not 6 times the strength; it is 5 backups. This size puts the most sustained strain on the heading of anything on the flag, so it is built two inches wide, heavy duty white and reinforced, with brass grommets and tooth washers.

Commercial grade nylon is the material in this flag. Light enough to catch a gentle breeze, it sheds water rather than holding onto it and dries fast, which keeps a flag from staying heavy and stressing its seams. The ink is UV resistant and field tested, since sun exposure is what determines how long the color lasts.

A design that reproduces cleanly

Two colors and no seal. It is one of the cheapest state flags to build well and one of the most durable, because there is no fine detail to crack or fade unevenly.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Alabama flag placed 29, at 6.06 out of 10.

Will it fit my flagpole?

It suits an in-ground flagpole of thirty to forty feet.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

The last size on grommets

Everything above this is finished with a rope sewn the full length of the heading rather than two grommets, because two points can no longer carry the load. The 6x10 foot flag sits right at that boundary, which is why it runs six rows of stitching and a two inch heading while still using grommets.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Underneath both tables is a single ratio: a flag a quarter to a third the flagpole’s height. When you land between two rows, that is a real choice, not a rounding error — smaller flies more often, bigger reads further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The proportion still applies past a hundred feet, but the decision changes character: the flagpole, the truck, the halyard, the foundation and the wind load stop being separate line items and become one engineered whole, and ordering a flag without confirming the flagpole rating puts the flagpole at risk first. A few famous flags fly deliberately larger than the rule suggests, and all of them do it with engineering behind the choice.

If a size in either table is missing from the website, it does not mean we do not carry it. The full range is available to order regardless of what is currently listed.

About the back of the flag

A printed flag's reverse face is a mirror image of the front, and that is standard, not a fault — it describes most of the flags flown across the country. Double sided construction, which reads correctly from either face, sews two flags together with a liner and roughly doubles both weight and price. Single sided remains standard, and correct, unless a state's statute specifically calls for double sided.

Flying it with the United States flag

Title 4, Section 7 of the United States Flag Code sets the rule: no flag flies above the United States flag, and none takes its place to the right at the same level, meaning the viewer’s left. Two equal-height flagpoles put the United States flag on the viewer’s left, with both flags matched in size. Unequal flagpoles put the United States flag on the taller one, and a single flagpole with two flags carries the United States flag at the top. Civilians are not bound by penalty under the Flag Code, but it remains the standard institutions follow.

Buy two and they both last longer

Alternate two flags on a monthly schedule and you will get more life from both than from three flags flown until they wear out, because resting fabric recovers and the fly end stops absorbing the same repeated stress. A severe storm is the one condition worth taking the flag down for; it can do more damage in a night than six calm months. The fly end frays first, not the center, and stitching it early adds a season.

For cities, counties, schools and agencies

This is a flag we sell to municipalities, school districts, fire and police departments, courthouses and state agencies as standard business. Use the tax exempt page for a tax exempt account, and the contact page for quantity orders, a replacement schedule, or a size not shown on this listing.

Why buy it from us

We run a small American company and stock the flags we sell. Each one is made in the United States, printed in UV resistant ink, and built to the construction described above instead of built to hit a lower price. One durable flag beats three that fail, in our view. Free shipping applies to orders over twenty five dollars.