Alabama 12x18 Feet Nylon State Flag Made in USA

Two hundred and sixteen square feet puts a 12x18 foot flag in major-installation territory — civic sites, memorial grounds, highway locations, anywhere the flag has to read from a long way off.

This is the Alabama state flag at 12x18 Feet (216 square feet) in nylon, made in the United States and finished with a sewn rope and plated steel thimbles.

Built to the Alabama flag specification

The Alabama flag is set out in Alabama Code Section 1-2-5. It is a crimson St. Andrew’s cross, a saltire, on a white field, with the bars required to be not less than six inches broad.

Adopted February 16, 1895 by Act 383, introduced by its designer, Representative John W. A. Sanford Jr.

Alabama Code Section 1-2-5 says nothing about the overall size or even the shape. The only absolute measurement in it is that the saltire bars be not less than six inches broad, which on a small flag is proportionally impossible to satisfy and has never once been enforced. The Attorney General addressed the shape question in 1987 and concluded that where the statute is silent, precedent and practice govern.

The reproduction here is faithful to the design, in the standard outdoor sizes used industry wide and bought by the states themselves. On an outdoor flag, correct colors, seal and emblems are what counts, and that is what you get.

The law that defines it, in its own words

Code of Alabama Section 1-2-5 reads:

The flag of the State of Alabama shall be a crimson cross of St. Andrew on a field of white. The bars forming the cross shall be not less than six inches broad, and must extend diagonally across the flag from side to side.

You do not have to take our word for any of that. Read Code of Alabama Section 1-2-5 in full at Justia, and check what we sell against it.

That is the flag we build, not a rough version of it.

What is on it and what it means

The statute itself describes only a crimson saltire on white. It carries no seal and no lettering, which is why it reads clearly from a distance at every size.

What most listings get wrong

Because the statute sets a minimum bar width of six inches, a very small flag technically does not meet the legal definition. That is a curiosity rather than a problem, but it is the kind of detail nobody else on the internet mentions.

Where the Alabama flag flies

A thirty eight by twenty foot flag on a seventy foot pole at Camp Liberty in Cullman County is billed only as Cullman County's largest, not a statewide record.

Fly it on Alabama’s birthday

Alabama became the 22nd state on December 14, 1819. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Alabama flag has an official reason to go up.

Order it ahead of the date and it is ready to fly that day. Every state’s birthday is listed on our state birthdays page.

Nylon or polyester in Alabama

Nylon inland at Birmingham, Montgomery, Huntsville and Tuscaloosa. Polyester on the Gulf Coast at Mobile for salt, humidity and hurricane exposure.

Take any flag down for tornado and tropical events.

For scale, the National Weather Service ultraviolet index forecast for Mobile on July 23, 2026 was 11 at solar noon, in the extreme band. That is the sun this flag has to survive.

At two hundred and sixteen square feet, an installation flag, any exposed site above that calls for polyester means it absolutely, with the flagpole engineered to carry it.

You are looking at the nylon here, the right pick for the sheltered and moderate wind sites named above, for any house bracket, and for anywhere the flag gets brought in during storms. Two things make that case. It is light enough to move on the breeze most yards actually get rather than hang limp, and it dries fast, which keeps mildew away in a humid climate. What it trades away is ultraviolet durability — nylon’s amide bonds break down under ultraviolet light, losing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. For one of the exposed sites named above, the polyester version is the better fit.

This is the detail people usually only figure out after buying twice: nylon will fly on a day too calm for polyester to move at all. If flying on a still morning, a holiday, at a funeral, or at a ceremony matters to you, that is reason enough to choose nylon even where polyester would survive longer. A motionless flag fails at its purpose regardless of how durable it is.

Institutions commonly cite the American Legion’s figure: the federal government expects about ninety days from a flag flown daily sunrise to sunset, and roughly a quarter of that flown around the clock. On the ground, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for occasional flying. Take these as working estimates, not warranties — exposure can move them a long way in either direction.

How the 12x18 Feet is built

Six rows of stitching and zig zag corners at this size are not decorative choices — they manage a load a house flag could not survive for one afternoon.

The arithmetic behind that: 216 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind the fly end of a flag this size travels faster than the wind itself, because the wave running out to the tip accelerates as it goes. That is why the tip wears out first and why the stitching count at that end is the number worth reading on any listing.

Two hundred and sixteen square feet is a scheduled operation, not an errand. Raise it and lower it with the site in mind, and never on a day the wind is already up.

Each lock stitch knots into the one beside it, so a broken thread stays broken right where it snapped instead of unraveling the whole seam. 6 rows is not 6 times the strength — it is 5 backups. A nylon rope sewn the full length of the heading with two plated steel thimbles, spreading the load across the entire hoist.

Nylon, commercial grade, is what this flag is made from. It is light enough to move in a gentle breeze, sheds rather than soaks up water, and dries quickly — a wet flag is a heavier flag, harder on its own seams. The ink is UV resistant and field tested, because sun exposure is what actually fades a flag.

A design that reproduces cleanly

Two colors and no seal. It is one of the cheapest state flags to build well and one of the most durable, because there is no fine detail to crack or fade unevenly.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Alabama flag placed 29, at 6.06 out of 10.

Will it fit my flagpole?

Sixty to eighty feet of in-ground flagpole, with hardware rated for it, is the right fit for this size.

Questions about the 12x18 Feet

What size flagpole for a 12x18 foot flag? Sixty to eighty feet with hardware engineered for two hundred and sixteen square feet of load.

Who buys a 12x18 foot state flag? Civic sites, memorial grounds, highway frontages and campuses, anywhere the flag is meant to be seen from a long way off.

Does a flag this size need special care? It needs a rotation, hardware checks, and taking down in severe weather. Flown properly it lasts. Flown carelessly it does not last a season.

This size is a commitment

A flag this large is a scheduled maintenance item rather than something you put up and forget. It wants a rotation, it wants the hardware checked, and it wants taking down in severe weather. Flown properly it lasts. Flown carelessly it does not last a season.

Specifications

• Size: 12x18 Feet
• Area: 216 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Rope and Thimbles
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

The proportion that makes both tables work is simple: length equal to roughly a quarter to a third of the flagpole’s height. Sitting between two sizes is common, and the choice there is really a trade between a flag that flies often and one that is seen from a distance.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Nothing about the ratio breaks above a hundred feet, but the purchase does: the flag, the flagpole, the truck, the halyard and the foundation become one system that has to be specified together, and skipping that check risks the flagpole before it risks the flag. Some of the largest flags flown in the country are deliberately oversized for their rule-of-thumb flagpole, always on an engineer’s sign-off.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

A printed flag reads correctly from the front and reversed from the back. That is normal and it is true of almost every flag flown in the country. A flag that reads correctly from both sides is a double sided flag, built as two flags sewn together with a liner between them, and it costs roughly twice as much and weighs roughly twice as much. Unless the statute for a particular state requires it, single sided is the standard and the right choice.

Flying it with the United States flag

The United States Flag Code, at Title 4, Section 7, sets this out: the United States flag holds the position of honor, never below another flag and never displaced from the viewer’s left when flags fly level. With two flagpoles of matching height, the United States flag takes the viewer’s left and the flags match in size; with unequal heights, it goes on the taller pole; on a single pole carrying two flags, it is at the top. The Code has no penalty attached for civilians, but it remains the standard every institution follows.

Buy two and they both last longer

Two flags, alternated month to month, beat three flags flown until they fall apart, because the material recovers on its days off and the fly end is not worked in the same place every day. Severe weather is the one time to take it down; a real windstorm can cost more in one night than six ordinary months of flying. Fraying starts at the fly end, not the middle, and a few minutes with a needle there adds a season.

For cities, counties, schools and agencies

Fire and police departments, school districts, courthouses, municipalities and state agencies are all regular buyers of our state flags. Tax exempt purchasing is set up through the tax exempt page, and quantities, replacement schedules or an unlisted size are handled through the contact page.

Why buy it from us

We are a small company based in America, and we keep in stock what we sell. Every flag is made domestically, printed in UV resistant ink, and finished to the construction described above rather than scaled down to a price. Selling a flag that lasts matters more to us than selling three that don’t. Orders over twenty five dollars ship free.