FORTISVEX Wyoming State Flag 3x5 Feet Nylon - Made in USA with Brass Grommets

Ask someone to picture a flag and this is usually the size in their head. It matches the bracket most houses already have, and no other size gets replaced as often across the country.

This is the Wyoming state flag at 3x5 Feet (15 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Wyoming flag specification

The Wyoming flag is set out in Wyoming Statutes Section 8-3-102, with the seal at Section 8-3-101, at a seven to ten proportion. It is a blue field bordered in white then red, with a white bison silhouette carrying the state seal in blue on its flank.

Designed by Verna Keays for a Wyoming Daughters of the American Revolution contest in 1916 and adopted January 31, 1917.

Wyoming specifies proportions rather than a size. Section 8-3-102 sets the width at seven tenths of the length and defines the border, the stripe, the bison and the seal as fractions of the whole. Seven to ten is not a standard commercial size, and vexillologists have noted for years that manufacturers do not build to it.

The design here is reproduced faithfully, at the standard outdoor sizes the whole industry works in and that states buy for themselves. What actually matters on a flag flown outdoors is that the colors, the seal and the emblems are correct, and they are.

The law that defines it, in its own words

Wyoming Statutes Section 8-3-102, subsection (a) reads:

A state flag is adopted to be used on all occasions when the state is officially and publicly represented. All citizens have the privilege of use of the flag upon any occasion they deem appropriate. The width of the flag shall be seven-tenths (7/10) of its length; the outside border shall be in red, the width of which shall be one-twentieth (1/20) of the length of the flag; next to the border shall be a stripe of white on the four (4) sides of the field, which shall be in width one-fortieth (1/40) of the length of the flag. The remainder of the flag shall be a blue field, in the center of which shall be a white silhouetted buffalo, the length of which shall be one-half (1/2) of the length of the blue field; the other measurements of the buffalo shall be in proportion to its length. On the ribs of the buffalo shall be the great seal of the state of Wyoming in blue. The seal shall be in diameter one-fifth (1/5) the length of the flag. Attached to the flag shall be a cord of gold with gold tassels. The same colors shall be used in the flag, red, white and blue, as are used in the flag of the United States of America.

You do not have to take our word for any of that. Read Wyoming Statutes Section 8-3-102 in full at Justia, and check what we sell against it.

This is what we actually make, not a stand-in for it.

What is on it and what it means

The bison is the plains and the state’s wildlife. The seal branded on its flank represents livestock and the branding heritage. The seal figures carry Equal Rights, for Wyoming as the first territory to grant women the vote, alongside livestock, mining and grain.

Worth knowing about this flag

Keays drew the bison facing the fly. The version adopted reversed it to face the hoist, which is the one you fly today.

Where the Wyoming flag flies

Wyomingites obtain United States Capitol flags through the congressional delegation, residents only, with a flying and certificate fee plus shipping. the Governor routinely orders the Wyoming State flag specifically flown at half staff at the Capitol, sunrise to sunset, to honor individuals. The Capitol's gold leaf gilded copper dome, one of only about ten gold domed American capitols, was re-gilded five times, most recently during the 2016 to 2019 Capitol Square restoration, when a new copper dome and gilded finial were installed and the Capitol reopened on July 10, 2019.

Fly it on Wyoming’s birthday

Wyoming became the 44th state on July 10, 1890. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Wyoming flag has an official reason to go up.

Have it on hand before the date arrives and it is on the flagpole in time. The full state-by-state list is on our state birthdays page.

Nylon or polyester in Wyoming

Polyester statewide. Cheyenne at roughly 12.9 to 14.6 miles per hour is among the windiest American stations, and the state is known for relentless wind and high altitude ultraviolet.

Even polyester needs regular replacement here.

At fifteen square feet, a house flag, the flag material decides whether it flies on a light day and how fast it dries after rain.

The nylon is what you are looking at here — the right choice for the sheltered and moderate wind sites named above, for a house bracket, and for anywhere the flag comes down ahead of storms. Two things settle it. It is light enough to fly on an ordinary yard’s breeze rather than sag, and it dries fast, fighting mildew in humid conditions. What it gives up is resistance to ultraviolet — nylon’s amide bonds break under sun, costing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. If the site is one of the exposed ones above, the polyester version fits better.

One more thing that decides it, and it is the part people only learn after buying twice: a nylon flag flies on days a polyester flag will not. If the flag matters to you on a still morning, on a holiday, at a funeral, at a ceremony, that is an argument for this one even on a site where the polyester would last longer. A flag that hangs is not doing its job either.

The number most institutions rely on traces to the American Legion, which reports a roughly ninety-day expectation from the federal government for a flag flown daily sunrise to sunset, and about a quarter of that flown around the clock. Retailer experience puts nylon at three to six months daily, polyester at four to eight, and an occasionally flown flag at one to three years. These figures are practical guidance, not a warranty, and exposure will move them considerably.

How the 3x5 Feet is built

This size fails at the fly end first, and sooner than it should on most 3x5 foot flags, because this size gets bought on price more than any other. Four rows of lock stitching at the fly end is what separates one season from three.

The math comes to 15 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind, the fly end moves faster than the wind that is driving it, since the wave headed for the tip speeds up as it travels — which explains why the tip wears out first and why fly-end stitching count is worth checking on any listing.

One person handles the whole job, up or down, and it folds into a drawer. A monthly two-flag rotation costs a minute of your time at this size.

A lock stitch ties into the stitch next to it, so one broken thread does not unzip the whole seam — it just stops. 4 rows is not 4 times the strength; it is 3 backups. An inch and a half wide, heavy duty white and reinforced, this heading carries two solid brass grommets. Fifteen square feet is enough sail area to work them hard in any real wind.

This flag is commercial grade nylon, light enough to move in a gentle breeze, and it sheds water instead of soaking it up, drying fast — which matters, since a wet flag is a heavy flag that works its own seams harder. UV resistant, field tested ink is what stands between the flag and the sun, since sun is what fades a flag over time.

Why this flag is harder to make than most

A large bison silhouette is straightforward, but the seal branded on its flank is fine detail inside a shape, which is harder than a seal on an open field.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Wyoming flag placed 23, at 6.28 out of 10.

Will it fit my flagpole?

A five or six foot house bracket or a fifteen to twenty foot in-ground flagpole both suit this size — the most common residential pairing in the country, and this is the size built for it.

Questions about the 3x5 Feet

What size flagpole does a 3x5 foot flag need? A six foot house bracket, or an in-ground flagpole of fifteen to twenty feet. It is the most common residential pairing in the country.

How long does a 3x5 foot nylon flag last outside? The federal working figure is about ninety days for a flag flown daily from sunrise to sunset, and about a quarter of that flown around the clock. Retailers commonly see three to six months in daily use and one to three years flown on occasions only.

Is this flag printed or sewn? The design is printed in UV resistant ink on one side and reads through in reverse on the back, which is how nearly every state flag sold in the country is made. The construction, the heading, the stitching and the grommets are sewn.

Why this size gets replaced most

This size is not inherently weaker. It is the one most commonly sold on price, so most of them are built cheaply. A 3x5 foot flag with only one or two rows of fly-end stitching frays in a season and loses six inches by the next. Construction explains the entire difference.

Specifications

• Size: 3x5 Feet
• Area: 15 square feet
• Material: 100 percent nylon
• Fly end: 4 rows of lock stitching
• Heading: heavy duty white, reinforced, 1-1/2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

There is one number behind both tables. A flag reads right when its length is somewhere between a quarter and a third of the flagpole it is on. If your flagpole puts you between two sizes, go smaller for a flag that flies more and lasts longer, or bigger for one that carries further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Nothing about the ratio breaks above a hundred feet, but the purchase does: the flag, the flagpole, the truck, the halyard and the foundation become one system that has to be specified together, and skipping that check risks the flagpole before it risks the flag. Some of the largest flags flown in the country are deliberately oversized for their rule-of-thumb flagpole, always on an engineer’s sign-off.

What is on the website is not the limit of what we carry. Any size in the tables above can be ordered, listed or not.

About the back of the flag

A single sided printed flag shows its design correctly on one face and reversed on the other. That is expected, and it describes almost every flag flying in the United States. A flag readable on both sides is built as two layers sewn around a liner, roughly double the cost and double the weight of a single sided flag. Unless a state’s law requires double sided, single sided remains the standard choice.

Flying it with the United States flag

Section 7 of Title 4, the United States Flag Code, addresses this directly: the United States flag is never outranked in position, staying above every other flag and to the right at the same level, which reads as the viewer’s left. Same-height flagpoles put the United States flag on the viewer’s left with matching flag sizes; different heights put it on the taller pole; one flagpole with two flags puts it at the top. There is no legal penalty for civilians under the Flag Code, but it is what every institution follows anyway.

Buy two and they both last longer

Buy two flags and swap them every month. That habit alone outlasts three flags flown into the ground, since the material recovers while resting and the fly end is not repeatedly stressed in the same place. Take the flag down for real storms; overnight wind damage can exceed six months of ordinary wear. Inspect the fly end rather than the middle, and a few minutes of repair stitching when fraying starts buys another season.

For cities, counties, schools and agencies

Fire and police departments, school districts, courthouses, municipalities and state agencies are all regular buyers of our state flags. Tax exempt purchasing is set up through the tax exempt page, and quantities, replacement schedules or an unlisted size are handled through the contact page.

Why buy it from us

This company is small and American, and what is on the site is in stock. Every flag here is made in the United States, uses UV resistant ink, and is built to the construction described above rather than priced down to a cheaper build. We would rather you buy one flag that lasts than replace three that do not. Orders over twenty five dollars get free shipping.