FORTISVEX Tennessee State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets

Residential ends here. A 6x10 foot flag is sixty square feet of commercial flag for a commercial flagpole — and the last size still finished with grommets rather than a sewn rope.

This is the Tennessee state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Tennessee flag specification

The Tennessee flag is set out in Chapter 498 of the Public Acts of 1905, at a proportion of three to five. It is a crimson field with three white stars in a blue circle, and a vertical blue bar bordered by white at the fly.

Designed by Colonel LeRoy Reeves of the Third Regiment, Tennessee Infantry, and adopted April 17, 1905.

The law governing this flag addresses design, colors and the seal or emblem, but leaves overall size unspecified for a modern outdoor flag. That is typical across most states, which is why the industry has converged on the same standard sizes.

The design here is reproduced faithfully, at the standard outdoor sizes the whole industry works in and that states buy for themselves. What actually matters on a flag flown outdoors is that the colors, the seal and the emblems are correct, and they are.

The law that defines it, in its own words

Tennessee Code Section 4-1-301, subsection (a) reads:

(a) The flag or banner of this state shall be of the following design, colors and proportions, to wit: an oblong flag or banner in length one and two-thirds (1 2/3) times its width, the principal field of same to be of color red, but the flag or banner ending at its free or outer end in a perpendicular bar of blue, of uniform width, running from side to side, that is to say, from top to bottom of the flag or banner, and separated from the red field by a narrow margin or stripe of white of uniform width; the width of the white stripe to be one-fifth (1/5) that of the blue bar; and the total width of the bar and stripe together to be equal to one-eighth (1/8) of the width of the flag. In the center of the red field shall be a smaller circular field of blue, separated from the surrounding red field by a circular margin or stripe of white of uniform width and of the same width as the straight margin or stripe first mentioned. The breadth or diameter of the circular blue field, exclusive of the white margin, shall be equal to one-half (1/2) of the width of the flag. Inside the circular blue field shall be three (3) five-pointed stars of white distributed at equal intervals around a point, the center of the blue field, and of such size and arrangement that one (1) point of each star shall approach as closely as practicable without actually touching one (1) point of each of the other two (2) around the center point of the field; and the two (2) outer points of each star shall approach as nearly as practicable without actually touching the periphery of the blue field. The arrangement of the three (3) stars shall be such that the centers of no two (2) stars shall be in a line parallel to either the side or end of the flag, but intermediate between same; and the highest star shall be the one nearest the upper confined corner of the flag.

Subsection (b) makes it an offense to knowingly manufacture or sell a state flag that does not comply with this design, and subsection (c) requires every Tennessee flag to carry markings showing the correct way to fly it. Ours does.

You do not have to take our word for any of that. Read Tennessee Code Section 4-1-301 in full at FindLaw, and check what we sell against it.

That is the flag we build, not a rough version of it.

What is on it and what it means

Reeves wrote it down himself. The three stars are the three Grand Divisions, East, Middle and West, bound together by the endless circle, an indissoluble trinity. The blue bar at the fly relieves the sameness of the crimson field.

What most listings get wrong

The three stars do not mean Tennessee was the third state after the original thirteen. Reeves rejected that reading personally, and it is still the most repeated claim about this flag. The bar at the fly is functional, so a limp flag still shows all three colors, not symbolic.

Where the Tennessee flag flies

Camping World in Sevierville flies a forty by eighty foot flag on a hundred and thirty foot pole. The City of Sevierville sued in 2025 because zoning caps poles at forty four feet. Well documented but not an adjudicated state record, and it is one of several identical installations nationwide.

Fly it on Tennessee’s birthday

Tennessee became the 16th state on June 1, 1796. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Tennessee flag has an official reason to go up.

Buy it in time and it goes up on the day it matters. Every state’s date is on our state birthdays page.

Nylon or polyester in Tennessee

Nylon statewide at Nashville, Memphis, Knoxville and Chattanooga. Polyester where severe storm wind is highest.

For scale, the National Weather Service ultraviolet index forecast for Memphis on July 23, 2026 was 7 at solar noon, in the high band. That is the sun this flag has to survive.

Sixty square feet makes this a commercial flag, and on an exposed site from the list above, the right material is the difference between one season and three.

You are looking at the nylon here, the right pick for the sheltered and moderate wind sites named above, for any house bracket, and for anywhere the flag gets brought in during storms. Two things make that case. It is light enough to move on the breeze most yards actually get rather than hang limp, and it dries fast, which keeps mildew away in a humid climate. What it trades away is ultraviolet durability — nylon’s amide bonds break down under ultraviolet light, losing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. For one of the exposed sites named above, the polyester version is the better fit.

The part most buyers learn only the second time around: nylon flies in wind too light to move polyester. When it matters that the flag is actually moving — a still morning, a holiday, a funeral, a ceremony — that favors nylon even somewhere polyester would last longer. A flag that hangs motionless is not doing its job either, however durable it is.

The working benchmark most institutions use comes from the American Legion, which reports that the United States government expects a flag flown daily from sunrise to sunset to last about ninety days, and one flown around the clock about a quarter of that. Retailer experience runs three to six months for nylon and four to eight for polyester flown daily, and one to three years for a flag flown only on occasions. Those are working figures, not a warranty, and exposure moves them a long way in either direction.

How the 6x10 Feet is built

At sixty square feet the force at the fly end outstrips anything a house flag sees, which is why the stitching steps up to six rows here instead of four.

The arithmetic behind that: 60 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind the fly end of a flag this size travels faster than the wind itself, because the wave running out to the tip accelerates as it goes. That is why the tip wears out first and why the stitching count at that end is the number worth reading on any listing.

Proper folding at this size needs two people and clear ground. Sixty square feet is too much fabric for a tailgate fold.

Lock stitching means each stitch is knotted into the next, so a broken thread stops where it broke rather than unzipping the seam. 6 rows does not mean 6 times the strength; it means 5 backups. This size puts the most sustained strain on the heading of anything on the flag, so it is built two inches wide, heavy duty white and reinforced, with brass grommets and tooth washers.

The flag material is commercial grade nylon. It is light enough to fly in a gentle breeze, it sheds water rather than holding it, and it dries fast, which matters because a flag that stays wet stays heavy and works its seams harder. The ink is UV resistant and field tested; sun is what takes a flag’s color, and the ink decides how long it holds.

A design that reproduces cleanly

A circle, three stars and a fly bar. No seal and no lettering, which is why it rates well and costs little.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Tennessee flag placed 14, at 6.98 out of 10.

Will it fit my flagpole?

An in-ground flagpole thirty to forty feet tall suits this flag.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

The last size on grommets

Everything above this is finished with a rope sewn the full length of the heading rather than two grommets, because two points can no longer carry the load. The 6x10 foot flag sits right at that boundary, which is why it runs six rows of stitching and a two inch heading while still using grommets.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

One rule sits under both tables: the flag should run about a quarter to a third the height of the flagpole. On the border between two rows, the smaller flag flies more and lasts longer; the larger one is the one you can see from the road.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Above roughly a hundred feet of flagpole, the quarter to a third guide keeps its accuracy but loses its simplicity: the flag now has to be specified alongside the truck, the halyard, the foundation and the wind load as a single system, and skipping that step is how a flagpole gets damaged rather than the flag. Several famous installations fly flags larger than the rule on purpose, with an engineer deciding it rather than a table.

We supply the whole range shown above, whether or not a given size currently has its own listing on the site. Ask if you do not see it.

About the back of the flag

It is normal for a printed flag to read backward from behind — almost every flag flown in America works this way. A flag that reads correctly from both sides is double sided: two flags sewn together with a liner, at roughly double the weight and cost. Single sided stays the standard and the right choice except where a state’s own law requires the double sided build.

Flying it with the United States flag

Governing this is Title 4, Section 7 of the United States Flag Code, which keeps the United States flag in the position of honor: never below another flag, never to the right of one at the same level, meaning never right of the viewer’s left. Two flagpoles at equal height put the United States flag at the viewer’s left with equal-sized flags; unequal heights put it on the taller pole; a single flagpole with two flags carries it at the top. No penalty attaches for private citizens under the Code, but it is what institutions follow as standard practice.

Buy two and they both last longer

One flag flown month after month wears faster at the same point every time; two flags rotated monthly outlast three run to failure, because rest lets fabric recover. Bring the flag in ahead of severe weather — a hard storm overnight can outdo six normal months. And check the fly end first, since that is where fraying starts, and a small stitch repair there is worth a full extra season.

For cities, counties, schools and agencies

We supply state flags to municipalities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts are handled through the tax exempt page. For quantities, replacement schedules or sizes not listed, use the contact page.

Why buy it from us

Small and American describes this company, and we stock what we list. Every flag is made in the United States, printed with UV resistant ink, and finished to the construction described above rather than to a price target. We’d rather sell one flag that holds up than three that don’t. Free shipping on orders over twenty five dollars.