FORTISVEX
FORTISVEX Kentucky State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets
- MPN:
- FPAMSTKYNYL6x10G
- Availability:
- Free Shipping* https://fortisvex.com/shipping-returns-terms/
- Shipping:
- Calculated at Checkout
Description
This is the size where a state flag leaves residential territory behind. Sixty square feet is commercial, flown on a commercial flagpole, and it is the last size built with grommets before rope takes over.
This is the Kentucky state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.
Built to the Kentucky flag specification
The Kentucky flag is set out in Kentucky Revised Statutes 2.030. It is a navy field with the state seal wreathed in goldenrod.
Adopted in 1918.
What is fixed by law here is the design, the colors and the seal or emblem — not a size requirement for an outdoor flag. Most states leave it the same way, which is why the whole industry has settled on the same standard sizes.
We build a faithful reproduction of that design at the standard outdoor sizes the industry uses, the same sizes states order for themselves. Correct colors, seal and emblems are what an outdoor flag has to get right, and that is what this one gets right.
The law that defines it, in its own words
Kentucky Revised Statutes Section 2.030 reads:
(1) The official state flag of the Commonwealth of Kentucky shall be of navy blue silk, nylon, wool or cotton bunting, or some other suitable material, with the seal of the Commonwealth encircled by a wreath, the lower half of which shall be goldenrod in bloom and the upper half the words "Commonwealth of Kentucky," embroidered, printed, painted, or stamped on the center thereof. The dimensions of the flag may vary, but the length shall be one and nine-tenths (1 9/10) times the width and the diameter of the seal and encirclement shall be approximately two-thirds (2/3) the width of the flag. (2) The approved official drawings of the state flag shall be permanently retained in the files of the office of the Secretary of State. All state flags for official use of the Commonwealth shall conform as to color and design with these official drawings.
The emblem itself is defined by reference to the seal, so these words are the frame and not the whole picture.
You do not have to take our word for any of that. Read Kentucky Revised Statutes Section 2.030 in full at FindLaw, and check what we sell against it.
This is the actual flag we manufacture, not an approximation.
What is on it and what it means
The seal shows two embracing men and the motto United We Stand, Divided We Fall. The goldenrod wreath is the state flower.
What most listings get wrong
The two figures are officially a frontiersman and a statesman. They are not Daniel Boone and Henry Clay. That misidentification appears on most retail listings and in a good deal of published reference material.
Where the Kentucky flag flies
Kentuckians obtain United States Capitol flags through congressional offices, with an online order form offering a choice of sizes and fabrics and personalized certificates.
Fly it on Kentucky’s birthday
Kentucky became the 15th state on June 1, 1792. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Kentucky flag has an official reason to go up.
Order ahead and this flag is ready for the day. The complete list of state birthdays lives on our state birthdays page.
Nylon or polyester in Kentucky
Nylon statewide at Louisville, Lexington and Bowling Green. Polyester where severe storm and tornado wind is a known factor.
For scale, the National Weather Service ultraviolet index forecast for Louisville on July 23, 2026 was 10 at solar noon, in the very high band. That is the sun this flag has to survive.
Sixty square feet makes this a commercial flag, and on an exposed site from the list above, the right material is the difference between one season and three.
This listing is nylon, right for the sheltered and moderate wind sites above, for a standard house bracket, and for anywhere you take the flag down before a storm. Two things make it the pick. It flies on the breeze most yards actually see instead of hanging flat, being light, and it dries fast, which fights mildew where humidity is high. What it sacrifices is ultraviolet resistance: nylon’s amide bonds absorb and break under sun, losing strength and color faster than polyester, plus roughly a tenth of its strength while wet. For an exposed site from the list above, the polyester version is the better choice.
Here is the part usually learned the hard way, after a second purchase: nylon catches wind on days polyester simply will not move. When the flag needs to be visibly flying — a quiet morning, a holiday, a funeral, a ceremony — that argues for nylon even on a site where polyester would technically last longer. A flag that just hangs there is not doing its job either.
The number most institutions rely on traces to the American Legion, which reports a roughly ninety-day expectation from the federal government for a flag flown daily sunrise to sunset, and about a quarter of that flown around the clock. Retailer experience puts nylon at three to six months daily, polyester at four to eight, and an occasionally flown flag at one to three years. These figures are practical guidance, not a warranty, and exposure will move them considerably.
How the 6x10 Feet is built
Six rows of lock stitching replace four at this size, because sixty square feet generates far more force at the fly end than any house flag experiences. Four rows would not hold.
The math comes to 60 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind, the fly end moves faster than the wind that is driving it, since the wave headed for the tip speeds up as it travels — which explains why the tip wears out first and why fly-end stitching count is worth checking on any listing.
Folding this properly takes two people and clear ground or a clean surface — sixty square feet will not fold neatly on a tailgate.
Each lock stitch knots into the one beside it, so a broken thread stays broken right where it snapped instead of unraveling the whole seam. 6 rows is not 6 times the strength — it is 5 backups. Two inches of reinforced heavy duty white heading carries brass grommets and tooth washers here — the part of the flag under the most sustained strain at this size.
This is commercial grade nylon: light enough to fly in a light wind, quick to shed water instead of holding it, and fast to dry, which matters because a waterlogged flag is a heavier flag putting more strain on its seams. UV resistant, field tested ink is what fights the sun, which is the real driver of color loss over time.
Why this flag is harder to make than most
Two human figures inside a floral wreath on navy. Faces are the hardest thing to hold at small print sizes and the goldenrod detail is the second hardest.
For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Kentucky flag placed 66, at 3.16 out of 10.
Will it fit my flagpole?
It suits an in-ground flagpole of thirty to forty feet.
Questions about the 6x10 Feet
What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.
Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.
Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.
The last size on grommets
This is the boundary: everything larger switches to a full-length sewn rope because two grommets cannot hold the load. The 6x10 foot flag runs six rows of stitching and a two inch heading while staying just inside the grommet range.
Specifications
- Size: 6x10 Feet
- Area: 60 square feet
- Material: 100 percent nylon
- Fly end: 6 rows of lock stitching
- Heading: heavy duty white, reinforced, 2 inch
- Finish: Brass Grommets
- Ink: UV resistant, field tested
- Made in the United States by FORTISVEX
Which size do I need?
The proportion that makes both tables work is simple: length equal to roughly a quarter to a third of the flagpole’s height. Sitting between two sizes is common, and the choice there is really a trade between a flag that flies often and one that is seen from a distance.
If you know your flagpole height, start here.
- 6 Feet house bracket: 2x3 Feet or 3x5 Feet
- 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
- 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
- 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
- 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
- 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
- 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
- 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
- 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
- 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
- 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
- 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
- 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole
If you know your flag size, start here.
- 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
- 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
- 4x6 Feet: 18 to 25 Feet in-ground flagpole
- 5x8 Feet: 25 to 35 Feet flagpole
- 6x10 Feet: 30 to 40 Feet flagpole
- 8x12 Feet: 40 to 50 Feet flagpole
- 10x15 Feet: 50 to 60 Feet flagpole
- 12x18 Feet: 60 to 80 Feet flagpole
- 15x25 Feet: 80 to 100 Feet flagpole
- 20x30 Feet: 100 to 120 Feet flagpole
- 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
- 30x50 Feet: 150 to 200 Feet flagpole
- 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
- 50x80 Feet: 240 Feet and above, engineered to the flagpole
That same ratio keeps working past a hundred feet, but at that point the flag and the flagpole are no longer separate purchases — the truck, the halyard, the foundation and the wind load all have to be sized together, and a flag chosen without checking the flagpole first damages the pole rather than itself. A handful of well known installations deliberately run past the rule of thumb, and every one of them did it with an engineer, not a chart.
Every size in both tables can be ordered, listed here or not. If the size you want does not appear on the website, contact us and we can still supply it.
About the back of the flag
A printed flag's reverse face is a mirror image of the front, and that is standard, not a fault — it describes most of the flags flown across the country. Double sided construction, which reads correctly from either face, sews two flags together with a liner and roughly doubles both weight and price. Single sided remains standard, and correct, unless a state's statute specifically calls for double sided.
Flying it with the United States flag
This is governed by the United States Flag Code, Title 4, Section 7: the United States flag always outranks every other flag in position, never displayed below it or to its right at the same level — right from the viewer’s side, that is. Two flagpoles of equal height place the United States flag at the viewer’s left with both flags the same size; if the poles differ in height, it goes on the taller pole; on one pole flying two flags, it sits at the top. The Flag Code carries no penalty for private citizens, but institutions treat it as the standard.
Buy two and they both last longer
Alternate two flags on a monthly schedule and you will get more life from both than from three flags flown until they wear out, because resting fabric recovers and the fly end stops absorbing the same repeated stress. A severe storm is the one condition worth taking the flag down for; it can do more damage in a night than six calm months. The fly end frays first, not the center, and stitching it early adds a season.
For cities, counties, schools and agencies
We regularly supply state flags to cities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts run through the tax exempt page. Quantity pricing, replacement schedules, or a size that is not listed all go through the contact page.
Why buy it from us
We are a small American company and we stock what we sell. Every flag here is made in the United States, printed in UV resistant ink, and finished to the construction described above rather than to a price point. We would rather sell you one flag that lasts than three that do not. Free shipping on orders over twenty five dollars.
Additional Information
Material Type: |
Commercial Nylon |
Flag Size: |
6x10 Feet |
Made in: |
USA |
Finish: |
Brass Grommets |