FORTISVEX Florida State Flag 6x10 Feet Nylon - Made in USA with Brass Grommets

This is the size where a state flag leaves residential territory behind. Sixty square feet is commercial, flown on a commercial flagpole, and it is the last size built with grommets before rope takes over.

This is the Florida state flag at 6x10 Feet (60 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Florida flag specification

The Florida flag is set out in Florida Statutes Section 15.012. It is a red saltire, a St. Andrew’s cross, on white with the state seal centered.

The cross was added by resolution in 1899 and ratified by voters November 6, 1900; the seal was standardized in 1985.

The design, the colors and the seal or emblem are set by statute; the size of a modern outdoor flag is not. That is the case in most of the country, and it is why manufacturers across the industry all build to the same standard sizes.

We reproduce that design faithfully, in the standard outdoor flag sizes the whole industry uses and that the states themselves buy. What matters on an outdoor flag is that the colors, the seal and the emblems are right, and they are.

The law that defines it, in its own words

Florida Statutes Section 15.012 reads:

The state flag shall conform with standard commercial sizes and be of the following proportions and description: The seal of the state, in diameter one-half the hoist, shall occupy the center of a white ground. Red bars, in width one-fifth the hoist, shall extend from each corner toward the center, to the outer rim of the seal.

The seal is defined at Section 15.03, by reference.

You do not have to take our word for any of that. Read Florida Statutes Section 15.012 in full at the Florida Senate, and check what we sell against it.

This is the actual flag we manufacture, not an approximation.

What is on it and what it means

The seal shows a Seminole woman, a sabal palm, a steamboat and sunshine. The documented official reason for the cross is plainer than people expect. Without it, the flag looked like a plain white flag of truce when it hung limp.

Worth knowing about this flag

Whether the saltire is a deliberate Confederate reference is argued either way. The surrender-flag rationale is the one the state itself documents. Florida is also one of only three state flags carrying the words In God We Trust.

Where the Florida flag flies

Bernice Braden Park in Cape Coral, two hundred and fifty feet, billed by the City of Cape Coral as the tallest free standing American flagpole in Florida. Community funded at about three hundred thousand dollars and raised on July 4, 2026. A prior claimant at Uptown Station in Fort Walton Beach, a hundred and seventy foot flagpole flying fifty by eighty foot flags, appears superseded.

Fly it on Florida’s birthday

Florida became the 27th state on March 3, 1845. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Florida flag has an official reason to go up.

Get it now so it is flying on the day itself. See every state’s birthday on our state birthdays page.

Nylon or polyester in Florida

Polyester statewide. Extreme ultraviolet, near universal salt exposure, afternoon thunderstorms and hurricane risk. Jacksonville, Miami, Tampa and Orlando all qualify.

Take flags down for named storms.

For scale, the National Weather Service ultraviolet index forecast for Miami on July 23, 2026 was 12 at solar noon, in the extreme band. That is the sun this flag has to survive.

This is a commercial flag at sixty square feet, and on the exposed sites named above, material choice separates a one-season flag from a three-season one.

What you have here is the nylon, appropriate for the sheltered and moderate wind sites listed above, for any house bracket, and for anywhere the flag is brought down during storms. Two things decide it: it is light, flying on an ordinary breeze rather than going limp, and it dries fast, which is the defense against mildew in humidity. The trade is ultraviolet durability — nylon’s amide bonds break under sun, fading and weakening faster than polyester, and it loses about a tenth of its strength wet. For an exposed site on the list above, the polyester version is worth a look instead.

There is one more factor, and most people only discover it after buying the wrong material once: a nylon flag moves on days a polyester flag stays limp. If it matters to you that the flag is actually flying on a still morning, a holiday, at a funeral, at a ceremony, that favors nylon even where polyester would outlast it. A flag hanging motionless has failed at its job too.

Most institutions work from the same benchmark, reported by the American Legion: the United States government's expectation is roughly ninety days for a flag flown daily sunrise to sunset, and about a quarter of that for one flown around the clock. In practice, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for a flag flown only on occasions. These are working numbers, not a guarantee, and exposure can move them substantially either way.

How the 6x10 Feet is built

At sixty square feet the force at the fly end outstrips anything a house flag sees, which is why the stitching steps up to six rows here instead of four.

Work the numbers and you get 60 square feet of nylon at roughly two ounces a square yard. At thirty miles an hour, the fly end actually outpaces the wind, because the wave running to the tip accelerates along the way — the reason the tip fails first, and the reason fly-end stitching count is the number that matters.

Folding this properly takes two people and clear ground or a clean surface — sixty square feet will not fold neatly on a tailgate.

A lock stitch ties into the stitch next to it, so one broken thread does not unzip the whole seam — it just stops. 6 rows is not 6 times the strength; it is 5 backups. At sixty square feet, the heading takes the most sustained strain of any part of the flag, which is why it runs two inches of reinforced heavy duty white with brass grommets and tooth washers.

This is commercial grade nylon: light enough to fly in a light wind, quick to shed water instead of holding it, and fast to dry, which matters because a waterlogged flag is a heavier flag putting more strain on its seams. UV resistant, field tested ink is what fights the sun, which is the real driver of color loss over time.

Why this flag is harder to make than most

A detailed multicolor seal sitting over a cross. The seal is the expensive part and the part that fades first.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Florida flag placed 34, at 5.17 out of 10.

Will it fit my flagpole?

An in-ground flagpole thirty to forty feet tall suits this flag.

Questions about the 6x10 Feet

What size flagpole for a 6x10 foot flag? Thirty to forty feet. At this size the flag is commercial and the flagpole has to be an in-ground pole with a truck and halyard.

Why does the 6x10 foot flag have grommets when the 8x12 foot flag has a rope? Sixty square feet is the most two brass grommets can be asked to carry. Above this the load is spread along a rope sewn the length of the heading.

Does a 6x10 foot flag need a heavier flagpole? A sixty square foot flag in a gust loads a flagpole hard. If the pole was sold for a 4x6 foot or 5x8 foot flag, check its rating before stepping up.

The last size on grommets

Past this size, construction shifts entirely to a sewn rope the length of the heading, since two grommets cannot carry the load any further. The 6x10 Feet sits exactly at that boundary — six rows of stitching, a two inch heading, and still grommets.

Specifications

• Size: 6x10 Feet
• Area: 60 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Both tables follow the same logic. A flagpole reads best with a flag whose length falls between a quarter and a third of its height. Where a size could go either way, smaller means more flying days and a longer life, bigger means more visibility at range.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Push the flagpole past a hundred feet and the same ratio still applies, but it stops being a simple lookup: the flag, the truck, the halyard, the foundation and the wind load need to be engineered as a unit, and skipping that step damages the flagpole before it damages the flag. A number of famous large flags deliberately break the rule of thumb, on an engineer’s word rather than a table’s.

We supply the whole range shown above, whether or not a given size currently has its own listing on the site. Ask if you do not see it.

About the back of the flag

The back of a printed flag shows the design reversed, not missing. That is true of almost every flag in the country, and it is normal rather than a flaw. Getting both sides to read correctly means sewing two flags together with a liner between them, which roughly doubles the cost and the weight. Single sided is standard practice, and the right choice unless a particular state’s law says otherwise.

Flying it with the United States flag

Section 7 of Title 4, the United States Flag Code, addresses this directly: the United States flag is never outranked in position, staying above every other flag and to the right at the same level, which reads as the viewer’s left. Same-height flagpoles put the United States flag on the viewer’s left with matching flag sizes; different heights put it on the taller pole; one flagpole with two flags puts it at the top. There is no legal penalty for civilians under the Flag Code, but it is what every institution follows anyway.

Buy two and they both last longer

Two flags, alternated month to month, beat three flags flown until they fall apart, because the material recovers on its days off and the fly end is not worked in the same place every day. Severe weather is the one time to take it down; a real windstorm can cost more in one night than six ordinary months of flying. Fraying starts at the fly end, not the middle, and a few minutes with a needle there adds a season.

For cities, counties, schools and agencies

We supply state flags to municipalities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts are handled through the tax exempt page. For quantities, replacement schedules or sizes not listed, use the contact page.

Why buy it from us

Small and American describes this company, and we stock what we list. Every flag is made in the United States, printed with UV resistant ink, and finished to the construction described above rather than to a price target. We’d rather sell one flag that holds up than three that don’t. Free shipping on orders over twenty five dollars.