FORTISVEX Indiana State Flag 8x12 Feet Nylon - Made in USA with Rope and Thimbles

This is an institutional size. Ninety six square feet of flag, flown on a forty to fifty foot flagpole outside a civic building, a campus, a large commercial site — nobody buys this size without meaning to.

This is the Indiana state flag at 8x12 Feet (96 square feet) in nylon, made in the United States and finished with a sewn rope and plated steel thimbles.

Built to the Indiana flag specification

The Indiana flag is set out in Indiana Code Section 1-2-2-1. It is a gold torch surrounded by nineteen stars on blue, with the word Indiana above.

Designed by Paul Hadley through a Daughters of the American Revolution contest and adopted May 31, 1917 as the state banner for the 1916 centennial; the legislature’s only change to Hadley’s design was adding the word Indiana.

Design, colors and the seal or emblem are what this state's statute defines; a fixed size for an outdoor flag is not among them. Most of the country works the same way, and that is why manufacturers all build to the same standard sizes.

Faithfully reproduced, that is the standard we hold this design to, at the outdoor sizes the whole industry uses and states themselves order. What an outdoor flag needs right is the color, the seal and the emblems, and this one has them right.

The law that defines it, in its own words

Indiana Code Section 1-2-2-1 reads:

A state flag is hereby adopted, and the same shall be of the following design and dimensions, to-wit: Its dimensions shall be three (3) feet fly by two (2) feet hoist; or five (5) feet fly by three (3) feet hoist; or any size proportionate to either of those dimensions. The field of the flag shall be blue with nineteen (19) stars and a flaming torch in gold or buff. Thirteen (13) stars shall be arranged in an outer circle, representing the original thirteen (13) states; five (5) stars shall be arranged in a half circle below the torch and inside the outer circle of stars, representing the states admitted prior to Indiana; and the nineteenth star, appreciably larger than the others and representing Indiana shall be placed above the flame of the torch. The outer circle of stars shall be so arranged that one (1) star shall appear directly in the middle at the top of the circle, and the word "Indiana" shall be placed in a half circle over and above the star representing Indiana and midway between it and the star in the center above it. Rays shall be shown radiating from the torch to the three (3) stars on each side of the star in the upper center of the circle.

You do not have to take our word for any of that. Read Indiana Code Section 1-2-2-1 in full at the Indiana Historical Bureau, and check what we sell against it.

That is the flag as we build it. Nothing about it is approximate.

What is on it and what it means

The torch is liberty and enlightenment and its rays are a far-reaching influence. The thirteen outer stars are the original states. The five inner stars are the next five admitted. The single large star above the torch marks Indiana as the nineteenth state.

What most listings get wrong

It is still technically the state banner in the wording of the original act, not the state flag, though the code treats it as the flag.

Where the Indiana flag flies

Glenbrook Dodge in Fort Wayne. The original pole of about two hundred and thirty one feet, raised in 2001, snapped in a storm on December 23, 2022. A two hundred and thirteen foot replacement was raised on July 2, 2024, flying a fifty by eighty foot flag. The installer called the original the second tallest flagpole in the United States,.

Fly it on Indiana’s birthday

Indiana became the 19th state on December 11, 1816. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Indiana flag has an official reason to go up.

Indiana Day is December 11, a legal holiday under which the Indiana Code directs the governor to issue an annual proclamation and state schools to hold commemorative events.

Order ahead and this flag is ready for the day. The complete list of state birthdays lives on our state birthdays page.

Nylon or polyester in Indiana

Nylon statewide at Indianapolis, Fort Wayne and Evansville, except polyester in the open storm prone northwest near the lake.

At ninety six square feet the flagpole feels the load in earnest, and on an exposed site above, polyester is the only sensible material, with the flagpole and truck rated accordingly.

What you have here is the nylon, appropriate for the sheltered and moderate wind sites listed above, for any house bracket, and for anywhere the flag is brought down during storms. Two things decide it: it is light, flying on an ordinary breeze rather than going limp, and it dries fast, which is the defense against mildew in humidity. The trade is ultraviolet durability — nylon’s amide bonds break under sun, fading and weakening faster than polyester, and it loses about a tenth of its strength wet. For an exposed site on the list above, the polyester version is worth a look instead.

Here is the part usually learned the hard way, after a second purchase: nylon catches wind on days polyester simply will not move. When the flag needs to be visibly flying — a quiet morning, a holiday, a funeral, a ceremony — that argues for nylon even on a site where polyester would technically last longer. A flag that just hangs there is not doing its job either.

The working benchmark most institutions use comes from the American Legion, which reports that the United States government expects a flag flown daily from sunrise to sunset to last about ninety days, and one flown around the clock about a quarter of that. Retailer experience runs three to six months for nylon and four to eight for polyester flown daily, and one to three years for a flag flown only on occasions. Those are working figures, not a warranty, and exposure moves them a long way in either direction.

How the 8x12 Feet is built

The fly end carries six rows of lock stitching, and the corners use zig zag stitching rather than a straight seam, because a straight corner seam works loose under wind over a season.

The arithmetic behind that: 96 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind the fly end of a flag this size travels faster than the wind itself, because the wave running out to the tip accelerates as it goes. That is why the tip wears out first and why the stitching count at that end is the number worth reading on any listing.

Handling this size, on the ground or at the flagpole, is a two person job. A gust can take one person off balance while clipping ninety six square feet onto the halyard.

Each lock stitch knots into the one beside it, so a broken thread stays broken right where it snapped instead of unraveling the whole seam. 6 rows is not 6 times the strength — it is 5 backups. The grommets are gone at this size. A nylon rope is sewn the full length of the heading with two plated steel thimbles, so the load runs through the rope rather than tearing at two fixed points.

Nylon, commercial grade, is what this flag is made from. It is light enough to move in a gentle breeze, sheds rather than soaks up water, and dries quickly — a wet flag is a heavier flag, harder on its own seams. The ink is UV resistant and field tested, because sun exposure is what actually fades a flag.

A design that reproduces cleanly

A torch, nineteen stars and lettering, but no seal. That puts it well ahead of most states for durability and cost.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Indiana flag placed 32, at 5.77 out of 10.

Will it fit my flagpole?

Forty to fifty feet of in-ground flagpole, on a truck and halyard rather than a bracket, is the right fit.

Questions about the 8x12 Feet

What size flagpole for an 8x12 foot flag? Forty to fifty feet, on a truck and halyard rated for the load. This is an institutional flag.

What are the thimbles for? The rope sewn through the heading ends in two plated steel thimbles. The halyard snaps clip to the thimbles, so the pull runs through the rope along the whole hoist rather than tearing at two grommets.

Can an 8x12 foot flag fly around the clock? It can, on a lit flagpole, but a flag flown twenty four hours lasts roughly a quarter as long as one flown sunrise to sunset. Budget for that.

Why rope and thimbles carry most of the load

Two grommets concentrating ninety six square feet of pull onto two small brass rings does not hold, which is why a single reinforced grommet at the center of the heading now serves only as a secondary attachment point. A rope sewn the length of the heading spreads that load across the entire hoist and lets the thimbles take the attachment. It is more expensive to build and it is the only way a flag this size survives.

Specifications

• Size: 8x12 Feet
• Area: 96 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Rope, Thimbles and Center Grommet
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

The rule behind both tables below is that a flag’s length should run about a quarter to a third of the flagpole’s height. Where two sizes both fit, the smaller one flies more often and lasts longer, and the larger one reads from further away.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

The ratio does not fail at a hundred feet, but the transaction does change: past that height the flag, the flagpole, the truck, the halyard and the foundation have to be engineered together, and a flag ordered without checking the flagpole rating tends to cost the flagpole first. A few of the country’s best known flags deliberately exceed the rule, on the strength of an engineer’s calculation rather than a chart.

If a size in either table is missing from the website, it does not mean we do not carry it. The full range is available to order regardless of what is currently listed.

About the back of the flag

A printed flag reads correctly from the front and reversed from the back. That is normal and it is true of almost every flag flown in the country. A flag that reads correctly from both sides is a double sided flag, built as two flags sewn together with a liner between them, and it costs roughly twice as much and weighs roughly twice as much. Unless the statute for a particular state requires it, single sided is the standard and the right choice.

Flying it with the United States flag

Title 4, Section 7 of the United States Flag Code sets the rule: no flag flies above the United States flag, and none takes its place to the right at the same level, meaning the viewer’s left. Two equal-height flagpoles put the United States flag on the viewer’s left, with both flags matched in size. Unequal flagpoles put the United States flag on the taller one, and a single flagpole with two flags carries the United States flag at the top. Civilians are not bound by penalty under the Flag Code, but it remains the standard institutions follow.

Buy two and they both last longer

The simplest way to make a flag last is to own two and rotate them monthly — that alone outlasts three flags flown to failure, because rest lets the fabric recover and the fly end is not hammered day after day. Take it down ahead of real storms, since one bad night of wind can undo six good months. Watch the fly end, where fraying starts, and a quick repair there is worth a whole extra season.

For cities, counties, schools and agencies

State flags go out to municipalities, school districts, fire and police departments, courthouses and state agencies as a matter of course. Tax exempt purchasing runs through the tax exempt page, and anything involving quantity, a replacement schedule or a size we do not list goes through the contact page.

Why buy it from us

A small American company runs this store, and everything listed here is something we actually stock. Every flag is made in the United States, printed in UV resistant ink, and built to the construction described above rather than built down to a price. We would rather one flag last than sell three that fail early. Free shipping kicks in over twenty five dollars.