Rotating Crossbase and Waterbag
- Free Shipping* https://fortisvex.com/shipping-returns-terms/
- 9.00 LBS
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
|Buy 4||and pay only $59.50 each|
|Buy 8||and pay only $59.50 each|
|Buy 12||and pay only $59.25 each|
|Buy 16||and pay only $59.25 each|
|Buy 20||and pay only $59.10 each|
|Buy 24||and pay only $59.10 each|
|Buy 28||and pay only $59.00 each|
|Buy 32||and pay only $59.00 each|
|Buy 36||and pay only $58.89 each|
|Buy 40||and pay only $58.89 each|
The flag will rotate with a light breeze due to the ball bearing pole mounts. Flag is sold separately. Pole is sold separately.
This Rotating Crossbase and Waterbag requires purchasing of a pole and flag sold separately.
Price discount if purchased in cases. Each case comes with 4 Rotating Crossbass and Waterbag.
Part Number: CRW1
Made by Valley Forge Flag
Blade and Teardrop Flagpole Instructions:
Depending on the size of the pole that you are assembling you will have two
(BTS9), three (BTM12) or four (BTL16) pole sections. Always start with the
largest pole section. This piece is the bottom of the pole. Each section of the
pole slides into the next from largest to smallest until the pole is completely
Remove the bungee cord from the mesh pocket on the inside of the carrying
case. This is needed for flag attachment.
Slide the sleeve of the flag over the top of the pole. When you place the flag
on the pole the pole will bend to take the shape of the flag.
Loop the bungee through the leather tab on the bottom of the flag. Tighten
the bungee to provide enough tension for the flag to arch. Tie the bungee
cord to the knob located at the bottom of the pole to secure it in place.
There is a mounting hole in the bottom of these poles, which can be used
with a rotating ground spike or a crossbase with waterbag. The ground
spikes (TELGS) and crossbase with waterbag (CRW1) are not
included and must be purchased separately.