FORTISVEX Rhode Island State Flag 3x5 Feet Nylon - Made in USA with Brass Grommets

When most people picture a flag, this is the size they mean. It fits the bracket that already came with the house, and it is the single most replaced size in the country.

This is the Rhode Island state flag at 3x5 Feet (15 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Rhode Island flag specification

The Rhode Island flag is set out in the Rhode Island General Laws provisions on the state flag. It is a white field with a gold anchor encircled by thirteen gold stars and a blue ribbon carrying the motto Hope.

The current design was adopted in 1897.

Rhode Island General Laws Section 42-4-3 gives five feet six inches by four feet ten inches and then adds the words, or in these proportions. The statute authorizes scaling in as many words.

The design here is reproduced faithfully, at the standard outdoor sizes the whole industry works in and that states buy for themselves. What actually matters on a flag flown outdoors is that the colors, the seal and the emblems are correct, and they are.

The law that defines it, in its own words

Rhode Island General Laws Section 42-4-3 reads:

The flag of the state shall be white, five feet and six inches fly and four feet and ten inches deep on the pike, bearing on each side in the center a gold anchor, twenty-two inches high, and underneath it a blue ribbon twenty-four inches long and five inches wide, or in these proportions, with the motto "Hope" in golden letters thereon, the whole surrounded by thirteen (13) golden stars in a circle. The flag shall be edged with yellow fringe. The pike shall be surmounted by a spearhead and the length of the pike shall be nine feet, not including the spearhead.

The statute writes the measurements with foot and inch marks in parentheses; they are spelled out here.

You do not have to take our word for any of that. Read Rhode Island General Laws Section 42-4-3 in full at Justia, and check what we sell against it.

This is the flag we make. Not an approximation of it.

What is on it and what it means

The anchor is hope, a colonial symbol used since the seventeenth century. The thirteen stars are the original states and Rhode Island as one of them.

Worth knowing about this flag

It is one of only a handful of state flags on a white field, and it is normally made with gold fringe, which is part of the specification rather than an optional extra.

Where the Rhode Island flag flies

No citizen state capitol program was confirmed. the white state flag flies over one of the world's largest self supported marble domes. On Rhode Island Independence Day, the fourth of May, commemorating the 1776 Act of Renunciation in which Rhode Island was the first colony to renounce allegiance to King George the Third, the Department of State opens the State House on a special Saturday, encourages residents to display the state flag, and sells large Rhode Island flags at the State House Visitor's Center. The original Act of Renunciation is held by the Department of State and viewable at the State Archives.

Fly it on Rhode Island’s birthday

Rhode Island became the 13th state on May 29, 1790. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Rhode Island flag has an official reason to go up.

Have it on hand before the date arrives and it is on the flagpole in time. The full state-by-state list is on our state birthdays page.

Nylon or polyester in Rhode Island

Polyester leans favorable given near total coastal and Narragansett Bay salt exposure and wind at Providence. Nylon only well inland.

A house flag at fifteen square feet lives or dies on material choice for two reasons: flying in light wind, and drying speed after rain.

What you have here is the nylon, appropriate for the sheltered and moderate wind sites listed above, for any house bracket, and for anywhere the flag is brought down during storms. Two things decide it: it is light, flying on an ordinary breeze rather than going limp, and it dries fast, which is the defense against mildew in humidity. The trade is ultraviolet durability — nylon’s amide bonds break under sun, fading and weakening faster than polyester, and it loses about a tenth of its strength wet. For an exposed site on the list above, the polyester version is worth a look instead.

One more thing that decides it, and it is the part people only learn after buying twice: a nylon flag flies on days a polyester flag will not. If the flag matters to you on a still morning, on a holiday, at a funeral, at a ceremony, that is an argument for this one even on a site where the polyester would last longer. A flag that hangs is not doing its job either.

Institutions commonly cite the American Legion’s figure: the federal government expects about ninety days from a flag flown daily sunrise to sunset, and roughly a quarter of that flown around the clock. On the ground, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for occasional flying. Take these as working estimates, not warranties — exposure can move them a long way in either direction.

How the 3x5 Feet is built

The fly end is where this size gives out, and it gives out sooner than it should on most flags people buy, because the 3x5 foot flag is bought on price more than any other size. Four rows of lock stitching on the fly end is the difference between one season and three.

The math comes to 15 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind, the fly end moves faster than the wind that is driving it, since the wave headed for the tip speeds up as it travels — which explains why the tip wears out first and why fly-end stitching count is worth checking on any listing.

One person handles the whole job, up or down, and it folds into a drawer. A monthly two-flag rotation costs a minute of your time at this size.

Lock stitching means each stitch is knotted into the next, so a broken thread stops where it broke rather than unzipping the seam. 4 rows does not mean 4 times the strength; it means 3 backups. Two solid brass grommets sit in a reinforced, inch and a half heading. At fifteen square feet, there is enough sail area to put real strain on them whenever the site sees wind.

This flag is commercial grade nylon, light enough to move in a gentle breeze, and it sheds water instead of soaking it up, drying fast — which matters, since a wet flag is a heavy flag that works its own seams harder. UV resistant, field tested ink is what stands between the flag and the sun, since sun is what fades a flag over time.

A design that reproduces cleanly

An anchor, thirteen stars and a short motto. No seal, which keeps it well clear of the expensive end, though the white ground shows soiling.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Rhode Island flag placed 28, at 6.12 out of 10.

Will it fit my flagpole?

A five or six foot house bracket or a fifteen to twenty foot in-ground flagpole both suit this size — the most common residential pairing in the country, and this is the size built for it.

Questions about the 3x5 Feet

What size flagpole does a 3x5 foot flag need? A six foot house bracket, or an in-ground flagpole of fifteen to twenty feet. It is the most common residential pairing in the country.

How long does a 3x5 foot nylon flag last outside? The federal working figure is about ninety days for a flag flown daily from sunrise to sunset, and about a quarter of that flown around the clock. Retailers commonly see three to six months in daily use and one to three years flown on occasions only.

Is this flag printed or sewn? The design is printed in UV resistant ink on one side and reads through in reverse on the back, which is how nearly every state flag sold in the country is made. The construction, the heading, the stitching and the grommets are sewn.

Why this size gets replaced most

There is nothing weaker about the 3x5 foot flag itself — it is just the size most often bought on price, and built to match. A cheap one with one or two rows of stitching on the fly end frays inside a season and is six inches shorter within two. The construction is what separates the two.

Specifications

• Size: 3x5 Feet
• Area: 15 square feet
• Material: 100 percent nylon
• Fly end: 4 rows of lock stitching
• Heading: heavy duty white, reinforced, 1-1/2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

The proportion that makes both tables work is simple: length equal to roughly a quarter to a third of the flagpole’s height. Sitting between two sizes is common, and the choice there is really a trade between a flag that flies often and one that is seen from a distance.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Nothing about the ratio breaks above a hundred feet, but the purchase does: the flag, the flagpole, the truck, the halyard and the foundation become one system that has to be specified together, and skipping that check risks the flagpole before it risks the flag. Some of the largest flags flown in the country are deliberately oversized for their rule-of-thumb flagpole, always on an engineer’s sign-off.

Every size in both tables can be ordered, listed here or not. If the size you want does not appear on the website, contact us and we can still supply it.

About the back of the flag

Hold a printed flag up to the light and the reverse side shows the design in mirror image. That is not a defect — it is how nearly every flag flown in America is made. A flag correct on both sides is a double sided flag, two flags sewn together around a liner, and it runs roughly double the price and double the weight. Unless a state’s own statute calls for it, single sided is standard and it is the right call.

Flying it with the United States flag

Section 7 of Title 4, the United States Flag Code, addresses this directly: the United States flag is never outranked in position, staying above every other flag and to the right at the same level, which reads as the viewer’s left. Same-height flagpoles put the United States flag on the viewer’s left with matching flag sizes; different heights put it on the taller pole; one flagpole with two flags puts it at the top. There is no legal penalty for civilians under the Flag Code, but it is what every institution follows anyway.

Buy two and they both last longer

The simplest way to make a flag last is to own two and rotate them monthly — that alone outlasts three flags flown to failure, because rest lets the fabric recover and the fly end is not hammered day after day. Take it down ahead of real storms, since one bad night of wind can undo six good months. Watch the fly end, where fraying starts, and a quick repair there is worth a whole extra season.

For cities, counties, schools and agencies

Cities, school districts, fire and police departments, courthouses and state agencies buy state flags from us as a matter of routine. The tax exempt page is where a tax exempt account is set up; the contact page is where quantity orders, replacement schedules, and sizes not shown here get handled.

Why buy it from us

We are a small, American-based company that stocks what it lists. Every flag is made in the United States, uses UV resistant ink, and is finished to the standard described above rather than cut down to hit a price. One flag that lasts is worth more to us than three that do not. Free shipping applies over twenty five dollars.