FORTISVEX Texas State Flag 4x6 Feet Nylon - Made in USA Lone Star Flag with Brass Grommets

This is the first size that genuinely outgrows a house bracket and calls for a flagpole in the ground. The honest reason to buy a 4x6 foot flag is size, not looks.

This is the Texas state flag at 4x6 Feet (24 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Texas flag specification

The Texas flag is set out in Texas Government Code Chapter 3100, at a two to three proportion, with the statute giving precise star geometry. It is a blue vertical hoist stripe one third the length carrying a white five-pointed star, with white over red horizontal stripes.

This was the 1839 national flag of the Republic of Texas, drawn by Peter Krag and approved by President Lamar January 25, 1839; it became the state flag at annexation in 1845 and was re-adopted August 31, 1933 after a period with no active flag statute.

Texas is precise about proportion rather than size. Government Code Chapter 3100 requires a width to length ratio of two to three, which a 4x6 foot flag, an 8x12 foot flag and a 10x15 foot flag all match exactly. A 3x5 foot flag is a three to five ratio and is therefore slightly deeper than the statute describes.

This flag reproduces the design faithfully, built to the standard outdoor sizes used across the industry and bought by the states themselves. The colors, the seal and the emblems are the part that has to be right on an outdoor flag, and they are right here.

The law that defines it, in its own words

Texas Government Code Section 3100.002, Description: In General reads:

(a) The state flag is a rectangle that: (1) has a width to length ratio of two to three; and (2) contains: (A) one blue vertical stripe that has a width equal to one-third the length of the flag; (B) two equal horizontal stripes, the upper stripe white, the lower stripe red, each having a length equal to two-thirds the length of the flag; and (C) one white, regular five-pointed star: (i) located in the center of the blue stripe; (ii) oriented so that one point faces upward; and (iii) sized so that the diameter of a circle passing through the five points of the star is equal to three-fourths the width of the blue stripe. (b) The red and blue of the state flag are: (1) the same colors used in the United States flag; and (2) defined as numbers 193 (red) and 281 (dark blue) of the Pantone Matching System. (c) The red, white, and blue of the state flag represent, respectively, bravery, purity, and loyalty.

Section 3100.001 separately states that the state flag is the 1839 national flag of the Republic of Texas.

You do not have to take our word for any of that. Read Texas Government Code Section 3100.002 in full at the Texas Legislature, and check what we sell against it.

This is the actual flag we manufacture, not an approximation.

What is on it and what it means

The lone star stands for Texas unity, one for God, State and Country. Chapter 3100 assigns the colors directly: blue is loyalty, white is purity, red is bravery.

Worth knowing about this flag

For most of the late nineteenth and early twentieth century Texas had no flag statute in force. The 1933 act put the Lone Star Flag back into law.

With Hawaii, it is one of only two state flags that previously served as the flag of a sovereign nation.

Where the Texas flag flies

The original Battle Flag of San Jacinto has hung in the Texas House of Representatives at the State Capitol in Austin since 1933, with a reproduction displayed when the House is not in session to protect the fragile original. The World's Largest Texas Flag, one hundred by one hundred and fifty feet, was made by Dixie Flag and Banner of San Antonio and is unfurled at Longhorns football games.

Fly it on Texas’s birthday

Texas became the 28th state on December 29, 1845. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Texas flag has an official reason to go up.

Order ahead and this flag is ready for the day. The complete list of state birthdays lives on our state birthdays page.

Nylon or polyester in Texas

Polyester across the wind and ultraviolet Panhandle and West. Amarillo at 13.5 and Lubbock at 12.4 miles per hour are among the very windiest American stations, and El Paso for ultraviolet. Polyester also on the Gulf Coast at Houston and Corpus Christi. Nylon acceptable in the sheltered central metros at Austin, San Antonio and the Dallas interior.

Twenty four square feet is where wind load starts to matter in earnest, and the verdict above carries more weight here than on a standard house flag.

This listing is nylon, right for the sheltered and moderate wind sites above, for a standard house bracket, and for anywhere you take the flag down before a storm. Two things make it the pick. It flies on the breeze most yards actually see instead of hanging flat, being light, and it dries fast, which fights mildew where humidity is high. What it sacrifices is ultraviolet resistance: nylon’s amide bonds absorb and break under sun, losing strength and color faster than polyester, plus roughly a tenth of its strength while wet. For an exposed site from the list above, the polyester version is the better choice.

One more consideration, learned by most people only after a repeat purchase: a nylon flag moves in conditions where polyester hangs still. If the flag needs to actually be flying — a calm morning, a holiday, a funeral, a ceremony — that is an argument for nylon even on a site where polyester would technically outlast it. A flag that just hangs there has failed just as much as one that frays.

The working benchmark most institutions use comes from the American Legion, which reports that the United States government expects a flag flown daily from sunrise to sunset to last about ninety days, and one flown around the clock about a quarter of that. Retailer experience runs three to six months for nylon and four to eight for polyester flown daily, and one to three years for a flag flown only on occasions. Those are working figures, not a warranty, and exposure moves them a long way in either direction.

How the 4x6 Feet is built

A 4x6 foot flag carries well over half again the area of a 3x5 foot flag, so it catches proportionally more wind and the fly end works harder for it. Four rows of lock stitching, and it needs all four.

The arithmetic behind that: 24 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind the fly end of a flag this size travels faster than the wind itself, because the wave running out to the tip accelerates as it goes. That is why the tip wears out first and why the stitching count at that end is the number worth reading on any listing.

A one person job, technically, but the first windy day taking it down alone will make the size difference clear. Bring it in ahead of weather, not during it.

With lock stitching, every stitch knots into its neighbor, so damage stays contained at the break instead of running down the seam. Read 4 rows not as 4 times the strength but as 3 backups. The heading is heavy duty white and reinforced, an inch and a half wide, with two solid brass grommets and tooth washers. At twenty four square feet the load on those two points is real.

Commercial grade nylon is the material in this flag. Light enough to catch a gentle breeze, it sheds water rather than holding onto it and dries fast, which keeps a flag from staying heavy and stressing its seams. The ink is UV resistant and field tested, since sun exposure is what determines how long the color lasts.

A design that reproduces cleanly

Three colors and one star. It is among the cheapest state flags to build properly and among the longest lived, because there is no fine detail to fail.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Texas flag placed 2, at 8.13 out of 10.

Will it fit my flagpole?

An in-ground flagpole between eighteen and twenty five feet is the right fit; a six foot house bracket will leave it dragging and wrapping.

Questions about the 4x6 Feet

What flagpole does a 4x6 foot flag need? An in-ground flagpole of eighteen to twenty five feet. It is too large for a standard house bracket, which is the honest reason to choose it.

Is a 4x6 foot flag worth it over a 3x5 foot flag? Only if the flagpole is tall enough. On a twenty foot flagpole a 3x5 foot flag looks lost and a 4x6 foot flag fills it. On a six foot bracket the 4x6 foot flag will wrap.

Can I fly a 4x6 foot state flag with a 4x6 foot United States flag? Yes, and on two flagpoles of equal height that is the correct pairing, with the United States flag to the viewer’s left.

Where the step up starts to cost you

Going from a 3x5 foot flag to a 4x6 foot flag is where buying cheap begins to be expensive. The extra area means more force at the fly end and more load on the grommets, so a 4x6 Feet built to a budget fails faster than a 3x5 Feet built the same way. This is the size where construction stops being a nicety.

Specifications

• Size: 4x6 Feet
• Area: 24 square feet
• Material: 100 percent nylon
• Fly end: 4 rows of lock stitching
• Heading: heavy duty white, reinforced, 1-1/2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Both tables come down to one ratio: the flag’s length wants to be a quarter to a third of the flagpole’s height. When a size sits on the border between two rows, the smaller flag will fly on more days and outlast the bigger one, while the bigger flag is the one people notice from further off.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Nothing about the ratio breaks above a hundred feet, but the purchase does: the flag, the flagpole, the truck, the halyard and the foundation become one system that has to be specified together, and skipping that check risks the flagpole before it risks the flag. Some of the largest flags flown in the country are deliberately oversized for their rule-of-thumb flagpole, always on an engineer’s sign-off.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

A printed flag's reverse face is a mirror image of the front, and that is standard, not a fault — it describes most of the flags flown across the country. Double sided construction, which reads correctly from either face, sews two flags together with a liner and roughly doubles both weight and price. Single sided remains standard, and correct, unless a state's statute specifically calls for double sided.

Flying it with the United States flag

Title 4, Section 7 of the Flag Code is the source for this. The United States flag is never subordinate in position — nothing flies above it, and nothing takes its place at the viewer’s left when flags are level with each other. On matched flagpoles, the United States flag takes the viewer’s left and the flags should be sized the same; on unequal flagpoles, it goes on the taller one; and on a single pole flying two flags, it goes at the top. There is no penalty for civilians who do not follow the Code, but institutions treat it as the standard regardless.

Buy two and they both last longer

One flag flown month after month wears faster at the same point every time; two flags rotated monthly outlast three run to failure, because rest lets fabric recover. Bring the flag in ahead of severe weather — a hard storm overnight can outdo six normal months. And check the fly end first, since that is where fraying starts, and a small stitch repair there is worth a full extra season.

For cities, counties, schools and agencies

Our state flags go to municipalities, school districts, fire and police departments, courthouses and state agencies regularly. Tax exempt purchasing is handled on the tax exempt page. For quantity, a replacement schedule, or a size outside this listing, use the contact page.

Why buy it from us

A small American company runs this store, and everything listed here is something we actually stock. Every flag is made in the United States, printed in UV resistant ink, and built to the construction described above rather than built down to a price. We would rather one flag last than sell three that fail early. Free shipping kicks in over twenty five dollars.