Connecticut 8x12 Feet Nylon State Flag Made in USA

The 8x12 foot flag belongs to institutions: civic buildings, campuses, large commercial sites, on a flagpole forty to fifty feet tall. This is not a size anyone ends up with by accident.

This is the Connecticut state flag at 8x12 Feet (96 square feet) in nylon, made in the United States and finished with a sewn rope and plated steel thimbles.

Built to the Connecticut flag specification

The Connecticut flag is set out in Connecticut General Statutes Section 3-107, with the arms at Section 3-105. It is an azure field with a white rococo shield carrying three grapevines and the motto Qui Transtulit Sustinet. The statute gives exact dimensions of five feet six inches by four feet four inches, describing the silk ceremonial color rather than a standard outdoor size.

Adopted in 1897.

Connecticut General Statutes Section 3-107 fixes the flag at five feet six inches by four feet four inches in azure blue silk. That is a ceremonial color from 1897. Nobody makes an outdoor flag in that size and the state itself does not fly one.

We hold to a faithful reproduction of that design, at the standard outdoor sizes the industry uses and the states themselves buy. What matters on a flag that flies outdoors is accurate colors, seal and emblems, and that is exactly what this one has.

The law that defines it, in its own words

Connecticut General Statutes Section 3-107 reads:

The following-described flag is the official flag of the state. The dimensions of the flag shall be five feet and six inches in length, four feet and four inches in width. The flag shall be azure blue, charged with an argent white shield of rococo design, having in the center three grape vines, supported and bearing fruit in natural colors. The bordure to the shield shall be in two colors, gold on the interior and silver on the exterior, adorned with natural-colored clusters of white oak leaves (Quercus alba) bearing acorns. Below the shield shall be a white streamer, cleft at each end, bordered by a band of gold within fine brown lines, and upon the streamer in dark blue block letters shall be the motto "QUI TRANSTULIT SUSTINET"; the whole design being the arms of the state.

You do not have to take our word for any of that. Read Connecticut General Statutes Section 3-107 in full at Justia, and check what we sell against it.

This is what we actually make, not a stand-in for it.

What is on it and what it means

The motto translates as He Who Transplanted Sustains. The three grapevines trace to a seal of 1711 and stand for the early settlements and the transplantation of the colony itself.

Worth knowing about this flag

The statute specifies a fixed size rather than a ratio, which means a scaled flag is a departure from the letter of the law even though every manufacturer scales it.

Where the Connecticut flag flies

Each holds a significant Civil War battle flag collection. Connecticut's is at the Museum of Connecticut History in Hartford. Illinois has the State Military Museum in Springfield. Massachusetts has the State House Hall of Flags. Michigan runs a Save the Flags program with rotating display at the Capitol. Minnesota's Historical Society holds the First Minnesota's colors associated with Gettysburg.

The Milford Green flagpole, a hundred and ten feet, a fiberglass pole dedicated in 2014 replacing a ninety nine point seven foot steel pole. Milford's mayor described it as the tallest flagpole in the state. It flies a twenty five by thirty foot flag, was gifted by the Devon Rotary, and was made and installed by All American Flagpole of Woonsocket, Rhode Island. The prior notable pole is the hundred foot Newtown flagpole, which stands in the middle of a street intersection.

Fly it on Connecticut’s birthday

Connecticut became the 5th state on January 9, 1788. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Connecticut flag has an official reason to go up.

Have it on hand before the date arrives and it is on the flagpole in time. The full state-by-state list is on our state birthdays page.

Nylon or polyester in Connecticut

Nylon inland at Hartford. Polyester on Long Island Sound at Bridgeport, New Haven and Stamford for salt and coastal wind.

At ninety six square feet the flagpole feels the load in earnest, and on an exposed site above, polyester is the only sensible material, with the flagpole and truck rated accordingly.

This listing is the nylon. It is the right choice for the sheltered and moderate wind sites named above, on any house bracket, and anywhere the flag comes down in storms. Two things decide that. Nylon is light, so it flies on the breeze most yards actually get instead of hanging limp, and it dries fast, which is what fights mildew in a humid climate. What it gives up is ultraviolet life: nylon’s amide bonds absorb ultraviolet and break, so under hard sun it loses strength and color faster than polyester, and it loses roughly a tenth of its strength while it is wet. If your site is one of the exposed ones above, look at the polyester version of this flag instead.

Here is the part usually learned the hard way, after a second purchase: nylon catches wind on days polyester simply will not move. When the flag needs to be visibly flying — a quiet morning, a holiday, a funeral, a ceremony — that argues for nylon even on a site where polyester would technically last longer. A flag that just hangs there is not doing its job either.

Institutions commonly cite the American Legion’s figure: the federal government expects about ninety days from a flag flown daily sunrise to sunset, and roughly a quarter of that flown around the clock. On the ground, retailers report three to six months for nylon flown daily, four to eight for polyester, and one to three years for occasional flying. Take these as working estimates, not warranties — exposure can move them a long way in either direction.

How the 8x12 Feet is built

This size gets six rows of lock stitching on the fly end and zig zag stitched corners, since a straight-sewn corner is exactly what a season of wind will work open.

Work the numbers and you get 96 square feet of nylon at roughly two ounces a square yard. At thirty miles an hour, the fly end actually outpaces the wind, because the wave running to the tip accelerates along the way — the reason the tip fails first, and the reason fly-end stitching count is the number that matters.

Two people on the ground, two people at the flagpole: this size demands it. Ninety six square feet can knock you off balance in a gust while clipping it on alone.

Each lock stitch knots into the one beside it, so a broken thread stays broken right where it snapped instead of unraveling the whole seam. 6 rows is not 6 times the strength — it is 5 backups. At this size, grommets disappear. A nylon rope runs the full length of the heading, ending in two plated steel thimbles, spreading the load instead of concentrating it at two fixed points.

This is commercial grade nylon: light enough to fly in a light wind, quick to shed water instead of holding it, and fast to dry, which matters because a waterlogged flag is a heavier flag putting more strain on its seams. UV resistant, field tested ink is what fights the sun, which is the real driver of color loss over time.

Why this flag is harder to make than most

A fine rococo shield with three vines and a Latin motto. This is an arms-on-blue design, and the shield detail is where cheap reproductions fall apart first.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Connecticut flag placed 50, at 4.32 out of 10.

Will it fit my flagpole?

It suits an in-ground flagpole of forty to fifty feet, on a truck and halyard rather than a bracket.

Questions about the 8x12 Feet

What size flagpole for an 8x12 foot flag? Forty to fifty feet, on a truck and halyard rated for the load. This is an institutional flag.

What are the thimbles for? The rope sewn through the heading ends in two plated steel thimbles. The halyard snaps clip to the thimbles, so the pull runs through the rope along the whole hoist rather than tearing at two grommets.

Can an 8x12 foot flag fly around the clock? It can, on a lit flagpole, but a flag flown twenty four hours lasts roughly a quarter as long as one flown sunrise to sunset. Budget for that.

Why the grommets disappear

Ninety six square feet of pull, concentrated onto two small brass rings, is more than grommets can take. A rope sewn the full heading length spreads that load across the entire hoist, with thimbles carrying the attachment instead. It costs more to build, and it is the only way this size lasts.

Specifications

• Size: 8x12 Feet
• Area: 96 square feet
• Material: 100 percent nylon
• Fly end: 6 rows of lock stitching
• Heading: heavy duty white, reinforced, 2 inch
• Finish: Rope and Thimbles
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

The rule behind both tables below is that a flag’s length should run about a quarter to a third of the flagpole’s height. Where two sizes both fit, the smaller one flies more often and lasts longer, and the larger one reads from further away.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Above roughly a hundred feet of flagpole, the quarter to a third guide keeps its accuracy but loses its simplicity: the flag now has to be specified alongside the truck, the halyard, the foundation and the wind load as a single system, and skipping that step is how a flagpole gets damaged rather than the flag. Several famous installations fly flags larger than the rule on purpose, with an engineer deciding it rather than a table.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

It is normal for a printed flag to read backward from behind — almost every flag flown in America works this way. A flag that reads correctly from both sides is double sided: two flags sewn together with a liner, at roughly double the weight and cost. Single sided stays the standard and the right choice except where a state’s own law requires the double sided build.

Flying it with the United States flag

Title 4, Section 7 of the Flag Code is the source for this. The United States flag is never subordinate in position — nothing flies above it, and nothing takes its place at the viewer’s left when flags are level with each other. On matched flagpoles, the United States flag takes the viewer’s left and the flags should be sized the same; on unequal flagpoles, it goes on the taller one; and on a single pole flying two flags, it goes at the top. There is no penalty for civilians who do not follow the Code, but institutions treat it as the standard regardless.

Buy two and they both last longer

Buy two flags and swap them every month. That habit alone outlasts three flags flown into the ground, since the material recovers while resting and the fly end is not repeatedly stressed in the same place. Take the flag down for real storms; overnight wind damage can exceed six months of ordinary wear. Inspect the fly end rather than the middle, and a few minutes of repair stitching when fraying starts buys another season.

For cities, counties, schools and agencies

We regularly supply state flags to cities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts run through the tax exempt page. Quantity pricing, replacement schedules, or a size that is not listed all go through the contact page.

Why buy it from us

A small American company runs this store, and everything listed here is something we actually stock. Every flag is made in the United States, printed in UV resistant ink, and built to the construction described above rather than built down to a price. We would rather one flag last than sell three that fail early. Free shipping kicks in over twenty five dollars.