FORTISVEX Florida State Flag 4x6 Feet Nylon - Made in USA with Brass Grommets

This is the first size that genuinely outgrows a house bracket and calls for a flagpole in the ground. The honest reason to buy a 4x6 foot flag is size, not looks.

This is the Florida state flag at 4x6 Feet (24 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Florida flag specification

The Florida flag is set out in Florida Statutes Section 15.012. It is a red saltire, a St. Andrew’s cross, on white with the state seal centered.

The cross was added by resolution in 1899 and ratified by voters November 6, 1900; the seal was standardized in 1985.

What is fixed by law here is the design, the colors and the seal or emblem — not a size requirement for an outdoor flag. Most states leave it the same way, which is why the whole industry has settled on the same standard sizes.

What we build is a faithful reproduction of that design, sized to the standard outdoor sizes every manufacturer uses and the states themselves order in. On an outdoor flag, the colors, the seal and the emblems are what has to be right, and here they are.

The law that defines it, in its own words

Florida Statutes Section 15.012 reads:

The state flag shall conform with standard commercial sizes and be of the following proportions and description: The seal of the state, in diameter one-half the hoist, shall occupy the center of a white ground. Red bars, in width one-fifth the hoist, shall extend from each corner toward the center, to the outer rim of the seal.

The seal is defined at Section 15.03, by reference.

You do not have to take our word for any of that. Read Florida Statutes Section 15.012 in full at the Florida Senate, and check what we sell against it.

That is the flag we build, not a rough version of it.

What is on it and what it means

The seal shows a Seminole woman, a sabal palm, a steamboat and sunshine. The documented official reason for the cross is plainer than people expect. Without it, the flag looked like a plain white flag of truce when it hung limp.

Worth knowing about this flag

Whether the saltire is a deliberate Confederate reference is argued either way. The surrender-flag rationale is the one the state itself documents. Florida is also one of only three state flags carrying the words In God We Trust.

Where the Florida flag flies

Bernice Braden Park in Cape Coral, two hundred and fifty feet, billed by the City of Cape Coral as the tallest free standing American flagpole in Florida. Community funded at about three hundred thousand dollars and raised on July 4, 2026. A prior claimant at Uptown Station in Fort Walton Beach, a hundred and seventy foot flagpole flying fifty by eighty foot flags, appears superseded.

Fly it on Florida’s birthday

Florida became the 27th state on March 3, 1845. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Florida flag has an official reason to go up.

Buy it now and it is on the flagpole for the day. The full list of state birthdays is on our state birthdays page.

Nylon or polyester in Florida

Polyester statewide. Extreme ultraviolet, near universal salt exposure, afternoon thunderstorms and hurricane risk. Jacksonville, Miami, Tampa and Orlando all qualify.

Take flags down for named storms.

For scale, the National Weather Service ultraviolet index forecast for Miami on July 23, 2026 was 12 at solar noon, in the extreme band. That is the sun this flag has to survive.

At twenty four square feet the wind load starts to matter, and the verdict above applies with more force than it does to a house flag.

What you have here is the nylon, appropriate for the sheltered and moderate wind sites listed above, for any house bracket, and for anywhere the flag is brought down during storms. Two things decide it: it is light, flying on an ordinary breeze rather than going limp, and it dries fast, which is the defense against mildew in humidity. The trade is ultraviolet durability — nylon’s amide bonds break under sun, fading and weakening faster than polyester, and it loses about a tenth of its strength wet. For an exposed site on the list above, the polyester version is worth a look instead.

The part most buyers learn only the second time around: nylon flies in wind too light to move polyester. When it matters that the flag is actually moving — a still morning, a holiday, a funeral, a ceremony — that favors nylon even somewhere polyester would last longer. A flag that hangs motionless is not doing its job either, however durable it is.

The figure most institutions use is from the American Legion, citing the United States government's expectation of about ninety days for a flag flown daily from sunrise to sunset, and roughly a quarter of that around the clock. Retailers see three to six months in practice for nylon flown daily, four to eight for polyester, and one to three years when flown occasionally. These are practical figures, not a guarantee, and real-world exposure shifts them considerably.

How the 4x6 Feet is built

With well over half again the area of a 3x5 foot flag, a 4x6 Feet catches proportionally more wind, and the fly end pays for it. It carries four rows of lock stitching, and needs every one.

The math comes to 24 square feet of nylon at roughly two ounces a square yard. In a thirty mile an hour wind, the fly end moves faster than the wind that is driving it, since the wave headed for the tip speeds up as it travels — which explains why the tip wears out first and why fly-end stitching count is worth checking on any listing.

This remains a one person task, but a windy afternoon spent taking it down alone will show you the difference from a 3x5 Feet. Handle it before weather arrives.

A lock stitch ties into the stitch next to it, so one broken thread does not unzip the whole seam — it just stops. 4 rows is not 4 times the strength; it is 3 backups. The heading is reinforced heavy duty white, an inch and a half, with brass grommets and tooth washers taking a real load across twenty four square feet.

The flag material is commercial grade nylon. It is light enough to fly in a gentle breeze, it sheds water rather than holding it, and it dries fast, which matters because a flag that stays wet stays heavy and works its seams harder. The ink is UV resistant and field tested; sun is what takes a flag’s color, and the ink decides how long it holds.

Why this flag is harder to make than most

A detailed multicolor seal sitting over a cross. The seal is the expensive part and the part that fades first.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Florida flag placed 34, at 5.17 out of 10.

Will it fit my flagpole?

It suits an in-ground flagpole of eighteen to twenty five feet. On a six foot house bracket it will drag and wrap.

Questions about the 4x6 Feet

What flagpole does a 4x6 foot flag need? An in-ground flagpole of eighteen to twenty five feet. It is too large for a standard house bracket, which is the honest reason to choose it.

Is a 4x6 foot flag worth it over a 3x5 foot flag? Only if the flagpole is tall enough. On a twenty foot flagpole a 3x5 foot flag looks lost and a 4x6 foot flag fills it. On a six foot bracket the 4x6 foot flag will wrap.

Can I fly a 4x6 foot state flag with a 4x6 foot United States flag? Yes, and on two flagpoles of equal height that is the correct pairing, with the United States flag to the viewer’s left.

Where the step up starts to cost you

Going from a 3x5 foot flag to a 4x6 foot flag is where buying cheap begins to be expensive. The extra area means more force at the fly end and more load on the grommets, so a 4x6 Feet built to a budget fails faster than a 3x5 Feet built the same way. This is the size where construction stops being a nicety.

Specifications

• Size: 4x6 Feet
• Area: 24 square feet
• Material: 100 percent nylon
• Fly end: 4 rows of lock stitching
• Heading: heavy duty white, reinforced, 1-1/2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Underneath both tables is a single ratio: a flag a quarter to a third the flagpole’s height. When you land between two rows, that is a real choice, not a rounding error — smaller flies more often, bigger reads further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

That same ratio keeps working past a hundred feet, but at that point the flag and the flagpole are no longer separate purchases — the truck, the halyard, the foundation and the wind load all have to be sized together, and a flag chosen without checking the flagpole first damages the pole rather than itself. A handful of well known installations deliberately run past the rule of thumb, and every one of them did it with an engineer, not a chart.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

A single sided printed flag shows its design correctly on one face and reversed on the other. That is expected, and it describes almost every flag flying in the United States. A flag readable on both sides is built as two layers sewn around a liner, roughly double the cost and double the weight of a single sided flag. Unless a state’s law requires double sided, single sided remains the standard choice.

Flying it with the United States flag

Title 4, Section 7 of the United States Flag Code sets the rule: no flag flies above the United States flag, and none takes its place to the right at the same level, meaning the viewer’s left. Two equal-height flagpoles put the United States flag on the viewer’s left, with both flags matched in size. Unequal flagpoles put the United States flag on the taller one, and a single flagpole with two flags carries the United States flag at the top. Civilians are not bound by penalty under the Flag Code, but it remains the standard institutions follow.

Buy two and they both last longer

Buy two flags and swap them every month. That habit alone outlasts three flags flown into the ground, since the material recovers while resting and the fly end is not repeatedly stressed in the same place. Take the flag down for real storms; overnight wind damage can exceed six months of ordinary wear. Inspect the fly end rather than the middle, and a few minutes of repair stitching when fraying starts buys another season.

For cities, counties, schools and agencies

We supply state flags to municipalities, school districts, fire and police departments, courthouses and state agencies. Tax exempt accounts are handled through the tax exempt page. For quantities, replacement schedules or sizes not listed, use the contact page.

Why buy it from us

We are a small American company and we stock what we sell. Every flag here is made in the United States, printed in UV resistant ink, and finished to the construction described above rather than to a price point. We would rather sell you one flag that lasts than three that do not. Free shipping on orders over twenty five dollars.