FORTISVEX Alabama State Flag 3x5 Feet Nylon - Made in USA with Brass Grommets

This is the default: the size that fits the bracket already on the house, and the size Americans replace more than any other. When someone says flag without qualifying it, this is what they mean.

This is the Alabama state flag at 3x5 Feet (15 square feet) in nylon, made in the United States and finished with brass grommets.

Built to the Alabama flag specification

The Alabama flag is set out in Alabama Code Section 1-2-5. It is a crimson St. Andrew’s cross, a saltire, on a white field, with the bars required to be not less than six inches broad.

Adopted February 16, 1895 by Act 383, introduced by its designer, Representative John W. A. Sanford Jr.

Alabama Code Section 1-2-5 says nothing about the overall size or even the shape. The only absolute measurement in it is that the saltire bars be not less than six inches broad, which on a small flag is proportionally impossible to satisfy and has never once been enforced. The Attorney General addressed the shape question in 1987 and concluded that where the statute is silent, precedent and practice govern.

The reproduction here is faithful to the design, in the standard outdoor sizes used industry wide and bought by the states themselves. On an outdoor flag, correct colors, seal and emblems are what counts, and that is what you get.

The law that defines it, in its own words

Code of Alabama Section 1-2-5 reads:

The flag of the State of Alabama shall be a crimson cross of St. Andrew on a field of white. The bars forming the cross shall be not less than six inches broad, and must extend diagonally across the flag from side to side.

You do not have to take our word for any of that. Read Code of Alabama Section 1-2-5 in full at Justia, and check what we sell against it.

That is the flag as we build it. Nothing about it is approximate.

What is on it and what it means

The statute itself describes only a crimson saltire on white. It carries no seal and no lettering, which is why it reads clearly from a distance at every size.

What most listings get wrong

Because the statute sets a minimum bar width of six inches, a very small flag technically does not meet the legal definition. That is a curiosity rather than a problem, but it is the kind of detail nobody else on the internet mentions.

Where the Alabama flag flies

A thirty eight by twenty foot flag on a seventy foot pole at Camp Liberty in Cullman County is billed only as Cullman County's largest, not a statewide record.

Fly it on Alabama’s birthday

Alabama became the 22nd state on December 14, 1819. Under the United States Flag Code as amended July 7, 1976, a state flag flown on the state’s birthday takes its place beneath the United States flag, and that day is the one date every year the Alabama flag has an official reason to go up.

Have it on hand before the date arrives and it is on the flagpole in time. The full state-by-state list is on our state birthdays page.

Nylon or polyester in Alabama

Nylon inland at Birmingham, Montgomery, Huntsville and Tuscaloosa. Polyester on the Gulf Coast at Mobile for salt, humidity and hurricane exposure.

Take any flag down for tornado and tropical events.

For scale, the National Weather Service ultraviolet index forecast for Mobile on July 23, 2026 was 11 at solar noon, in the extreme band. That is the sun this flag has to survive.

At fifteen square feet, a house flag, the flag material decides whether it flies on a light day and how fast it dries after rain.

You are looking at the nylon here, the right pick for the sheltered and moderate wind sites named above, for any house bracket, and for anywhere the flag gets brought in during storms. Two things make that case. It is light enough to move on the breeze most yards actually get rather than hang limp, and it dries fast, which keeps mildew away in a humid climate. What it trades away is ultraviolet durability — nylon’s amide bonds break down under ultraviolet light, losing strength and color faster than polyester, and it loses roughly a tenth of its strength while wet. For one of the exposed sites named above, the polyester version is the better fit.

One more consideration, learned by most people only after a repeat purchase: a nylon flag moves in conditions where polyester hangs still. If the flag needs to actually be flying — a calm morning, a holiday, a funeral, a ceremony — that is an argument for nylon even on a site where polyester would technically outlast it. A flag that just hangs there has failed just as much as one that frays.

The working benchmark most institutions use comes from the American Legion, which reports that the United States government expects a flag flown daily from sunrise to sunset to last about ninety days, and one flown around the clock about a quarter of that. Retailer experience runs three to six months for nylon and four to eight for polyester flown daily, and one to three years for a flag flown only on occasions. Those are working figures, not a warranty, and exposure moves them a long way in either direction.

How the 3x5 Feet is built

Because the 3x5 foot flag is the size bought most often on price alone, it is also the size that fails first at the fly end. Four rows of lock stitching there is what buys the extra two seasons.

Work the numbers and you get 15 square feet of nylon at roughly two ounces a square yard. At thirty miles an hour, the fly end actually outpaces the wind, because the wave running to the tip accelerates along the way — the reason the tip fails first, and the reason fly-end stitching count is the number that matters.

Raising or lowering this size is a one person task, and it folds to fit a drawer. Rotating two flags monthly is a minute of effort, no more, at 3x5 Feet.

With lock stitching, every stitch knots into its neighbor, so damage stays contained at the break instead of running down the seam. Read 4 rows not as 4 times the strength but as 3 backups. Two solid brass grommets sit in a reinforced, inch and a half heading. At fifteen square feet, there is enough sail area to put real strain on them whenever the site sees wind.

This flag is commercial grade nylon, light enough to move in a gentle breeze, and it sheds water instead of soaking it up, drying fast — which matters, since a wet flag is a heavy flag that works its own seams harder. UV resistant, field tested ink is what stands between the flag and the sun, since sun is what fades a flag over time.

A design that reproduces cleanly

Two colors and no seal. It is one of the cheapest state flags to build well and one of the most durable, because there is no fine detail to crack or fade unevenly.

For what it is worth, the North American Vexillological Association surveyed 72 state, provincial and territorial flags in 2001 and rated them from zero to ten. The Alabama flag placed 29, at 6.06 out of 10.

Will it fit my flagpole?

A five or six foot house bracket or a fifteen to twenty foot in-ground flagpole both suit this size — the most common residential pairing in the country, and this is the size built for it.

Questions about the 3x5 Feet

What size flagpole does a 3x5 foot flag need? A six foot house bracket, or an in-ground flagpole of fifteen to twenty feet. It is the most common residential pairing in the country.

How long does a 3x5 foot nylon flag last outside? The federal working figure is about ninety days for a flag flown daily from sunrise to sunset, and about a quarter of that flown around the clock. Retailers commonly see three to six months in daily use and one to three years flown on occasions only.

Is this flag printed or sewn? The design is printed in UV resistant ink on one side and reads through in reverse on the back, which is how nearly every state flag sold in the country is made. The construction, the heading, the stitching and the grommets are sewn.

Why this size gets replaced most

There is nothing weaker about the 3x5 foot flag itself — it is just the size most often bought on price, and built to match. A cheap one with one or two rows of stitching on the fly end frays inside a season and is six inches shorter within two. The construction is what separates the two.

Specifications

• Size: 3x5 Feet
• Area: 15 square feet
• Material: 100 percent nylon
• Fly end: 4 rows of lock stitching
• Heading: heavy duty white, reinforced, 1-1/2 inch
• Finish: Brass Grommets
• Ink: UV resistant, field tested
• Made in the United States by FORTISVEX

Which size do I need?

Underneath both tables is a single ratio: a flag a quarter to a third the flagpole’s height. When you land between two rows, that is a real choice, not a rounding error — smaller flies more often, bigger reads further.

If you know your flagpole height, start here.

• 6 Feet house bracket: 2x3 Feet or 3x5 Feet
• 15 to 20 Feet flagpole: 3x5 Feet or 4x6 Feet
• 20 to 25 Feet flagpole: 4x6 Feet or 5x8 Feet
• 25 to 35 Feet flagpole: 5x8 Feet or 6x10 Feet
• 35 to 45 Feet flagpole: 6x10 Feet or 8x12 Feet
• 45 to 60 Feet flagpole: 8x12 Feet or 10x15 Feet
• 60 to 80 Feet flagpole: 10x15 Feet or 12x18 Feet
• 80 to 100 Feet flagpole: 12x18 Feet or 15x25 Feet
• 100 to 120 Feet flagpole: 15x25 Feet or 20x30 Feet
• 120 to 150 Feet flagpole: 20x30 Feet or 20x38 Feet
• 150 to 200 Feet flagpole: 20x38 Feet or 30x50 Feet
• 200 to 240 Feet flagpole: 30x50 Feet or 30x60 Feet
• 240 Feet and above: 30x60 Feet or 50x80 Feet, engineered to the flagpole

If you know your flag size, start here.

• 2x3 Feet: 4 to 8 Feet bracket or garden flagpole
• 3x5 Feet: 6 Feet bracket, or 15 to 20 Feet in-ground flagpole
• 4x6 Feet: 18 to 25 Feet in-ground flagpole
• 5x8 Feet: 25 to 35 Feet flagpole
• 6x10 Feet: 30 to 40 Feet flagpole
• 8x12 Feet: 40 to 50 Feet flagpole
• 10x15 Feet: 50 to 60 Feet flagpole
• 12x18 Feet: 60 to 80 Feet flagpole
• 15x25 Feet: 80 to 100 Feet flagpole
• 20x30 Feet: 100 to 120 Feet flagpole
• 20x38 Feet: 120 to 150 Feet flagpole. This is the garrison size under Executive Order 10834, at a one to one point nine ratio rather than the two to three of the commercial sizes, and it is the size flown at the White House and the Capitol
• 30x50 Feet: 150 to 200 Feet flagpole
• 30x60 Feet: 200 to 240 Feet flagpole. This is the largest standard commercial size
• 50x80 Feet: 240 Feet and above, engineered to the flagpole

Above roughly a hundred feet of flagpole, the quarter to a third guide keeps its accuracy but loses its simplicity: the flag now has to be specified alongside the truck, the halyard, the foundation and the wind load as a single system, and skipping that step is how a flagpole gets damaged rather than the flag. Several famous installations fly flags larger than the rule on purpose, with an engineer deciding it rather than a table.

We do not limit ourselves to what is listed on the site. The full range above is available to order, and an unlisted size can still be supplied.

About the back of the flag

A printed flag reads correctly from the front and reversed from the back. That is normal and it is true of almost every flag flown in the country. A flag that reads correctly from both sides is a double sided flag, built as two flags sewn together with a liner between them, and it costs roughly twice as much and weighs roughly twice as much. Unless the statute for a particular state requires it, single sided is the standard and the right choice.

Flying it with the United States flag

Section 7 of Title 4, the United States Flag Code, addresses this directly: the United States flag is never outranked in position, staying above every other flag and to the right at the same level, which reads as the viewer’s left. Same-height flagpoles put the United States flag on the viewer’s left with matching flag sizes; different heights put it on the taller pole; one flagpole with two flags puts it at the top. There is no legal penalty for civilians under the Flag Code, but it is what every institution follows anyway.

Buy two and they both last longer

Buy two flags and swap them every month. That habit alone outlasts three flags flown into the ground, since the material recovers while resting and the fly end is not repeatedly stressed in the same place. Take the flag down for real storms; overnight wind damage can exceed six months of ordinary wear. Inspect the fly end rather than the middle, and a few minutes of repair stitching when fraying starts buys another season.

For cities, counties, schools and agencies

State flags go out to municipalities, school districts, fire and police departments, courthouses and state agencies as a matter of course. Tax exempt purchasing runs through the tax exempt page, and anything involving quantity, a replacement schedule or a size we do not list goes through the contact page.

Why buy it from us

A small American company runs this store, and everything listed here is something we actually stock. Every flag is made in the United States, printed in UV resistant ink, and built to the construction described above rather than built down to a price. We would rather one flag last than sell three that fail early. Free shipping kicks in over twenty five dollars.